Re: L3 port-channel interface issue.

I think you are using NM-16ESW or HWIC-4ESW / HWIC-D-9ESW .
Please refer to data sheet . I dont think thats supported .

Thnx
Gaurav Madan
CCIE # 23863

On Sun, Oct 24, 2010 at 3:55 PM, Mahmoud Nossair
<mahmoud.nossair_at_gmail.com> wrote:
> Dear Experts
>
>
>
> I am facing a problem when mapping IEWB-Vol1 to GNS3, that I cannot create
> Layer3 Port-Channel interface on 3725 router? Is there is any solution for
> this problem.
>
>
>
> Here is the output:
>
>
>
> SW2(config)#interface fastEthernet 1/10
>
> SW2(config-if)#
>
> SW2(config-if)#
>
> SW2(config-if)#shutdown
>
> SW2(config-if)# no switchport
>
> SW2(config-if)# channel-group 1 mode on
>
> ^
>
> % Invalid input detected at '^' marker.
>
>
>
>
>
> While it can be on L2 interface (with switchport command)
>
>
>
>
>
> Best Regards,
>
>
>
> ==============================
>
> Mahmoud Nossair
>
> Senior Network Engineer.
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Mon Oct 25 2010 - 18:58:19 ART