Re: WCCP

Raghav,

The reason that I suspected this could be a ProxySG installation is that
Bluecoat guys in their demos sometimes use this particular configuration.

Anyway, as far as I remember this service group arrangement works for HTTP
and streaming - bear in mind; for every single vendor (e.g. Cisco WAAS goes
for 61/62) you need to double check with them to see what their
recommendations are. Generally speaking "yes" in many installations it does
make a difference to change the position of a service number. For the
service number itself, you do have to consult with that particular vendor.

HTH

Kambiz Agahian

CCIE Instructor/Consultant
M.Eng Telecom, CCIE# 25341, CCSI# 33326, MCSE, MCSA

On Wed, Oct 6, 2010 at 10:45 PM, Raghav Bhargava <raghavbhargava12_at_gmail.com
> wrote:

> Hey guys,
>
> Its not a proxySG installation. but why i asked that was like lets say in
> your network you have various vlans on which you need to enable wccp . Now
> is it mandatory that you should create different service-groups or only one
> service -group will work for all the vlans.
>
> HTH
>
> Raghav
>
>
> On Wed, Oct 6, 2010 at 5:58 PM, Kambiz Agahian <aussiecert_at_gmail.com>wrote:
>
>> If that's the case; the same story as 61/62 applies to them, the 11 enjoys
>> an assignment type based off of the source IP address while the 10 uses the
>> destination address in the hash process.
>>
>> Do you know the distribution best practices? again who's the vendor of the
>> WCCP "receiver"?
>>
>> HTH
>>
>>
>>
>> Kambiz Agahian
>>
>> CCIE Instructor/Consultant
>> M.Eng Telecom, CCIE# 25341, CCSI# 33326, MCSE, MCSA
>>
>>
>> On Wed, Oct 6, 2010 at 5:53 PM, Kambiz Agahian <aussiecert_at_gmail.com>wrote:
>>
>>> Hi Raghav,
>>>
>>> Is this a ProxySG installation for streaming traffic ?
>>>
>>>
>>> Kambiz Agahian
>>>
>>> CCIE Instructor/Consultant
>>> M.Eng Telecom, CCIE# 25341, CCSI# 33326, MCSE, MCSA
>>>
>>>
>>>
>>>
>>> On Wed, Oct 6, 2010 at 5:20 PM, Raghav Bhargava <
>>> raghavbhargava12_at_gmail.com> wrote:
>>>
>>>> Hi Experts,
>>>>
>>>> Need some advise on WCCP.
>>>>
>>>> sample configuration:
>>>>
>>>> ip wccp 10 redirect-list 2
>>>> ip wccp 11 redirect-list 2
>>>> !
>>>> interface gi0/1
>>>> ip wccp 10 redirect in
>>>> !
>>>> interface gi0/2
>>>> ip wccp 11 redirect in
>>>>
>>>> My question is can i use the same service number i.e 10 instead of 11
>>>> under
>>>> the interface gi0/2. If yes what difference will it make ??
>>>>
>>>>
>>>> --
>>>> Warm Regards
>>>> Raghav
>>>>
>>>>
>>>> Blogs and organic groups at http://www.ccie.net
>>>>
>>>> _______________________________________________________________________
>>>> Subscription information may be found at:
>>>> http://www.groupstudy.com/list/CCIELab.html
>>>>
>>>>
>>>>
>>>>
>>>>
>>>>
>>>>
>>>>
>>>
>>
>
>
> --
> Warm Regards
> Raghav

Blogs and organic groups at http://www.ccie.net
Received on Thu Oct 07 2010 - 08:50:42 ART