RE: Please confirm (conf#5e360d51ebe82a8f2fdb9ebfd3cbe087)

-----Original Message-----
From: mail_at_groupstudy.com [mailto:mail_at_groupstudy.com] On Behalf Of Cisco
certification
Sent: Monday, October 04, 2010 1:56 AM
To: zhushaofeng_at_163.com
Subject: Please confirm (conf#5e360d51ebe82a8f2fdb9ebfd3cbe087)

Hi,

You have tried to post to a GroupStudy.com certification mailing list.
Because the server does not recognize you as a confirmed poster, you will be
required to authenticate that you are using a valid e-mail address and are
not a spammer. By confirming this e-mail you certify that you are not
sending Unsolicited Bulk Email (UBE).

PLEASE DO NOT SEND YOUR ORIGINAL MESSAGE AGAIN! BY CONFIRMING THIS EMAIL
YOUR ORIGINAL MESSAGE (WHICH IS NOW QUEUED IN THE SERVER) WILL BE POSTED.

By confirming this e-mail you also certify the following:

1. The message does NOT break Cisco's Non-Disclosure requirements.

2. The message is NOT designed to advertise a commercial product.

3. You understand all postings become property of GroupStudy.com

4. You have searched the archives prior to posting.

5. The message is NOT inflammatory.

6. The message is NOT a test message.

To confirm, simply reply to this message. No editing is necessary. Once
confirmed, you will be able to post without additional confirmations.

Welcome to GroupStudy.com!

First time posters to GroupStudy.com are required to agree to the GroupStudy
terms and conditions.
Replying to this email, certifies you have read and agree to the GroupStudy
posting guidelines and terms and conditions.

--- Original Message Follows ---

From: "zhushaofeng" <zhushaofeng_at_163.com>
To: "'Cisco certification'" <ccielab_at_groupstudy.com>
Subject: GNS3 with 3560 switch
Date: Mon, 4 Oct 2010 01:58:04 +0800

Hi all:
I use GNS3 plus one 3560G switch to do router-on-a-stick lab, the nic is HP
NC364T QuadPort which support 802.1q VLAN.

But the the switch and router can not ping each other.

Using show cdp nei command on the 3560, the switch can see the router
(fa0/0.147 only ) but just for a while, later will disappear.

The router can not see switch totally. Anyone have such experience ?

The config is below:

Router: 3 subinterface fa0/0.147(native), fa0/0.100(vlan 100), fa0/0.200(
vlan 200)
           encap dot1q.
           vlan 100 and vlan 200 configred with ip.

Swtich: gi0/2 (trunk encap do1q) which is connect to the router fa0/0
           vlan 147 is native vlan
            vlan 100 and vlan 200 configured witch ip.

HP NC364T QuadPort: 802.1q enable
                     vlan 147(native); vlan 100 and vlan 200.

Router---------->cloud(3560 switch)-------->win2003 server witch SP2.

Thanks and Regards

Shaofeng

Blogs and organic groups at http://www.ccie.net
Received on Mon Oct 04 2010 - 02:05:35 ART