Re: Dynamips support to more than 16 ports on a single switch

Hi Ernesto and Alejandro,

Have you tried running, say 3660 with two NM-16SW?
I ran it before and it worked out just fine in adding more than 16 ports.
However, please keep in mind on the slot/port pair.
You may see different port range for each 16-port groups.

i.e.: port 1/1-1/16, followed by 2/1-2/16.

The way dynamips works is very close to the actual module being inserted
into each router's chassis.
So, to answer your question: yes it is possible.
But, you need to remember the slot/port pair in order to use the correct
(FE) port.

Hope that helps.

Cheers,

Dwi

On Sun, Sep 12, 2010 at 10:49 AM, Alejandro Glez. Zorrilla <
alexxandrozz_at_gmail.com> wrote:

> Hello experts,
>
> We have been working using Dynamips with the NM-16SW module; the problem is
> that we need ports 17 to 24
> Have any of you know how to write dynamips code and rewrite the second
> NM-16SW to continue the sequence from 17 to 32?
>
> or another method to rename hardware interfaces to continue the sequence
>
> Another avenue may be using the Cisco3745 that supports a NMD-36-ESW
> We ran the c3745-adventerprisek9-mz.124-15.T14.bin IOS without issues, now
> we would to see if any of you is working to support the NMD-36-ESW module
> on Dynamips?
>
> Best regards
> Ernesto and Alejandro
> CCIE Lab Students
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sun Sep 12 2010 - 10:57:07 ART