Re: OT-Foundry Netiron problem-driving me crazy

Dear All,

Thanks for reply

by default IP routing is enable on NetIron XMR switches .
Infact I have 20 port 10/100/1000 module .I have created one routed port
with static ip address.
port 18 has assigned ip address 10.1.1.1 /24 and connect to PC -10.1.1.2 /24
but unable to ping directly connected PC and from PC can not ping 10.1.1.1
which is assigned to port 18.

It is very strange problem

When I checked show arp on switch ,I can see PC ARP .Firewall is disabled
on PC.
I changed cable and even slot but same problem .
I have compared firmware with One working but same problem .
When I tried to sniff ,I observed that when switch send icmp echo to PC ,PC
send echo-reply but switch can not understand and it is getting timed out.

any output

Thanks
Prashant

On Sat, Sep 4, 2010 at 10:42 AM, Radioactive Frog <pbhatkoti_at_gmail.com>wrote:

> Hi Prashant,
> This beast is a little bit different compared to other foundry switches.
> You can do OOB or inband management to switch.
>
> For OOB:
>
> enable
> erase startup-config
>
> config t
> interface management 1
> ip address 1.1.1.1 255.255.255.0
> enable
>
> then enable the telnet server
>
> config t
> telnet server
>
> I am assuming you're running BASE image.
>
>
> HTH
>
>
> On Fri, Sep 3, 2010 at 6:07 PM, jockey wearer <jockeywearer_at_gmail.com>wrote:
>
>> Dear All,
>>
>> Its OT .i am working for one project and facing very basic problem between
>> two Foundry netiron switches .I have successfully completed many foundry
>> projects but with BigIron .
>> My two foundry netiron switches are connected to each other by direct 1G
>> Fastethernet cable .It has 20 port 10/100/1000 ethernet module .
>> I have connected it by cross cable and assigned ip address on interfaces
>> directly .it has basic configuration but I can not ping it .
>> If i check show arp it shows be arp value for next device but cant ping no
>> access-list .It is directly connectd link .
>> I checked post operation -everything fine
>> I tried different interfaces with same config same problem .If I tried 10G
>> to 10g connectivity same problem .
>> but interface is UP and LINE Protocol is also
>>
>> If anybody has any idea please help me .
>>
>> Thanks
>> Prashant
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sat Sep 04 2010 - 23:19:33 ART