Re: Catalyst 3750 - show policy-map interface command

THE SHOW service-policy interface command does not work use  show mls qos
commands and look at dscp marking packet counts and IN/OUT of PROFILE:

SW2#sh mls qos interface g0/1 statistics
GigabitEthernet0/1

dscp: incoming
-

0  4 : 95083 0 0 0 0
5  9 : 0 0 0 0 0
10  14 : 0 0 0 0 0
15  19 : 0 0 0 0 0
20  24 : 0 0 0 0 0
25  29 : 0 0 0 0 0
30  34 : 0 0 0 0 0
35  39 : 0 0 0 0 0
40  44 : 0 0 0 0 0
45  49 : 0 0 0 201 0
50  54 : 0 0 0 0 0
55  59 : 0 0 0 0 0
60  64 : 0 0 0 0
dscp: outgoing
-

0  4 : 47321 0 0 0 0
5  9 : 0 0 0 0 0
10  14 : 0 0 0 0 0
15  19 : 0 0 0 0 0
20  24 : 0 0 0 0 0
25  29 : 0 0 0 0 0
30  34 : 0 0 0 0 0
35  39 : 0 0 0 0 0
40  44 : 0 0 0 0 0
45  49 : 0 0 0 200 0
50  54 : 0 0 0 0 0
55  59 : 0 0 0 0 0
60  64 : 0 0 0 0
cos: incoming
-

0  4 : 96226 0 0 0 0
5  7 : 0 167 1945
cos: outgoing
-
0  4 : 47323 0 0 0 0
5  7 : 0 16 185
Policer: Inprofile: 770 OutofProfile: 245757

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12
.2_25_se/configuration/guide/swqos.html#wp1021811

*Note *Do not use the* show policy-map* *interface* privileged EXEC command
to display classification information for incoming traffic. The
*interface*keyword is not supported, and the statistics shown in the
display should be
ignored.

--
Garry L. Baker
"There is no 'patch' for stupidity." - www.sqlsecurity.com
On Tue, Aug 31, 2010 at 11:37 AM, emir d souza <emir979_at_gmail.com> wrote:
> Hi,
>
> I'm not seeing any output (0 packets 0 bytes) using this command, despite
> having marked the traffic.
>
> How do I verify that my traffic is actually being marked and queued
> correctly?
>
> regards,
>
> emir
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
>  http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net