Re: Dynamips With 3560 Switches

Thanks Artem , Michael & Hammer,
                                     I have used 3560 as breakout switch for
the testing.
Yes , i missed to configure the QinQ in the switches . So i will try again
,if i need more help i will ask.

Regards,
Anbu

On Thu, Aug 26, 2010 at 12:17 AM, Artem Nedoshepa <artem.nedoshepa_at_gmail.com
> wrote:

> You won't be able to see CDP packets unless your breakout switch is 3750.
>
> L2 Protocol Tunneling is not supported on Trunk Interfaces on the 3550
>
> The cheaper solution is to use Quad Nics. You can check my miniblog:
> ccie4you.info
>
>
>
> On Wed, Aug 25, 2010 at 2:25 PM, Anbu <ksanpu_at_gmail.com> wrote:
>
>> Hi
>> I have tried to connect the 3560 switches with Dynamips with the help of
>> some old mails in this group.But It is not working . So i need help to
>> make
>> it success.
>>
>> * The Connectivity is*
>>
>> Dynamips SVR -------------0/15 Breakout_SW 0/1---------------0/1 3560_SW
>> Breakout_Sw 0/15 = Trunk Port
>> Breakout_Sw 0/1 = Access Port (Vlan101) = Connected to the 3560 Switch.
>>
>>
>> .....

Blogs and organic groups at http://www.ccie.net
Received on Thu Aug 26 2010 - 08:09:37 ART