Re: OT:Wireless Controller Module Problem

What do you mean?Because the only place where I am asked to put a country is
the controller.

On Tue, Aug 24, 2010 at 1:21 AM, <oghenetejiri.groupstudy_at_gmail.com> wrote:

> Last time I had this issue it was a mismatch country code option, maybe you
> shd check that out.
>
> Cheer
>
> ORUKPE Oghenetejiri
>
> Sent from my BlackBerry. smartphone from Zain Nigeria
>
> -----Original Message-----
> From: karim jamali <karim.jamali_at_gmail.com>
> Sender: nobody_at_groupstudy.com
> Date: Mon, 23 Aug 2010 22:44:02
> To: Adrian Brayton<abrayton_at_gmail.com>; Cisco certification<
> ccielab_at_groupstudy.com>
> Reply-To: karim jamali <karim.jamali_at_gmail.com>
> Subject: Re: OT:Wireless Controller Module Problem
>
> The link between the switch & router is a trunk passing 2 VLANs (service
> VLANs mapped to SSID as tagged) and the native VLAN being untagged. The AP
> as well as the Controller are in the same VLAN. The AP is already has an
> LWAP image.
>
> Any help would be highly appreciated!
>
> On Mon, Aug 23, 2010 at 10:37 PM, Adrian Brayton <abrayton_at_gmail.com>
> wrote:
>
> > Have you make the link a trunk? I am not sure about the cool plug in
> module
> > but I have used 4402's and you need to tag the traffic.
> >
> > Also, if the WLC is going to be the brains of the operation then you have
> > to downgrade the image to a LWAPP image on the AP!
> >
> > HTHs
> >
> >
> > On Aug 23, 2010, at 3:09 PM, karim jamali wrote:
> >
> > > Dear Experts,
> > >
> > > I am not an expert on the wireless side of things not even close. I
> have
> > a
> > > router (3945) running the WLCM. The problem I am facing is that the AP
> is
> > > not registering with the WLCM. Note that I have configured the 2
> > interfaces
> > > (AP-Manager/Mgmt) interface with appropriate IP addresses, and are
> within
> > > the same subnet as the AP. Note that I am able to reach the Mgmt ip of
> > the
> > > controller as well as AP-Manager from the AP, however no registration
> is
> > > taking place.
> > >
> > > The scenario is as follows:
> > > AP--Edge Switch--Core--Router--WLCM
> > >
> > > Note that the Core is running the DHCP and has option 43 pointing to
> the
> > > management IP address, I even tried the AP Manager interface of the
> > > controller using the (option 43 ip 192.168.55.12).
> > >
> > > Can someone help propose/suggest a document, or give me a hint?
> > >
> > > Thanks
> > >
> > >
> > >
> > >
> > > --
> > > KJ
> > >
> > >
> > > Blogs and organic groups at http://www.ccie.net
> > >
> > > _______________________________________________________________________
> > > Subscription information may be found at:
> > > http://www.groupstudy.com/list/CCIELab.html
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> >
> >
>
>
> --
> KJ
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

--
KJ
Blogs and organic groups at http://www.ccie.net