RE: Not able to access -GNS3 0.7.2 Qemu from Windows 7 -32bit

You cannot boot an ASA in gns3 with just the cisco binary. You will need the
initrd and kernel packed files. Qemu loads up one (linux) and then you can run
the ASA software (lina). Make sure you get the right files though - some boot
but don't run right including no connectivity or no ability to configure.
Travis

-----Original Message-----
From: Kambiz Agahian
Sent: 8/23/2010 7:51:51 PM
To: Akber Ali Mirza
Cc: CCIE Lab
Subject: Re: Not able to access -GNS3 0.7.2 Qemu from Windows 7 -32bit
Akber,

I understand GNS3 has some compatibility issues with Windows 7. I'm not
quite sure about this one, yet I'd strongly recommend that you take a peek
at and even post a copy of your question to http://7200emu.hacki.at/ . It's
very likely that you get a technical response from the guys who're actually
involved in the project in this regard.

Kambiz Agahian

CCIE Instructor/Consultant
M.Eng Telecom, CCIE# 25341, CCSI# 33326, MCSE, MCSA

On Mon, Aug 23, 2010 at 3:14 AM, Akber Ali Mirza
<akberali.cisco_at_gmail.com>wrote:

> Hello Guys,
>
> Please help me out to access GNS3 0.7.2 Qemu from Windows 7 -32bit .
>
> I have mapped the asa 802-k8 image for the ASA in Qemu, but when i right
> click on the ASA icon it gets open and close
>
> Can you Please let me know the setting required to make it working fine.
>
> I am able to access Router through console and configure.
>
> E:\New-folder\Personal\IOS\asa802-k8.bin in Initrd and Kernel.
>
> Thanks in Adavance.
>
> Regards,
> Akber Mirza.
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Mon Aug 23 2010 - 20:16:18 ART