Re: vrf forwarding applied on physical or virtual-templeate

You will have to configure aaa local on the router. Tie the username to the aaa
config so that once they authenticate via chap it calls the right aaa config and
applies the vrf to the virtual-access interface...

________________________________
From: garry baker <baker.garry_at_gmail.com>
To: Prakash Kalsaria <kalsaria.prakash_at_gmail.com>
Cc: Cisco certification <ccielab_at_groupstudy.com>; Cisco certification
<comserv_at_groupstudy.com>; Cisco certification <cisco_at_groupstudy.com>
Sent: Sat, July 31, 2010 9:56:45 AM
Subject: Re: vrf forwarding applied on physical or virtual-templeate

is the IP of the Unnumbered f0/1 in the VRF?

you can manually set the ospf router-id to correct that if need be i would
imagine

interesting combo of vrf with pppoe i will have to lab it up...

you have a simple diagram of your setup or sh run from the client/server?

--
Garry L. Baker
"There is no 'patch' for stupidity." - www.sqlsecurity.com
On Sat, Jul 31, 2010 at 5:51 PM, Prakash Kalsaria <
kalsaria.prakash_at_gmail.com> wrote:
> My Virtual templeate has an IP from Unnumbered fa0/1
>
> but when i apply the vrf for on Virtual-template than i am able to form a
> adjacency
> even after i put mtu 1492 on dialer
>
> when i start the OSPF process
> it say cannot take a router-id for the OSPF proccess
>
> is it we have to apply it on both Virtual-templeate and physical Interface
>
> Thanks for the Reply
>
> Regards,
> http://prakashkalsaria.wordpress.com
>
>
>
> On Sat, Jul 31, 2010 at 8:14 PM, Muzammil Malick <malickmuz_at_gmail.com
> >wrote:
>
> > Prakash
> >
> > You are using a virtual-template therefore you would need to configure
> > your ip address on the virtual-template.
> > This tells me that you would need to configure the virtual -template
> > to forward the VRF otherwise the ip address
> > will not be routable in the VRF you require.
> >
> >
> > On 31 July 2010 15:18, Prakash Kalsaria <kalsaria.prakash_at_gmail.com>
> > wrote:
> > > I have a router which is a server for the PPPoE session and is a PE for
> a
> > > VPN site
> > > now were do i apply a Vrf forwarding on physical interface /
> > > virtual-templeate
> > > or on Both
> > >
> > >
> > > http://prakashkalsaria.wordpress.com
> > >
> > >
> > > Blogs and organic groups at http://www.ccie.net
> > >
> > > _______________________________________________________________________
> > > Subscription information may be found at:
> > > http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html