Re: Sparse mode autorp listener

Thanks. I had nothing in the routing table. I reloaded my routers and
forgot to add the router OSPF. *facepalm*

On Wed, Jun 30, 2010 at 12:07 PM, Adrian Brayton <abrayton_at_gmail.com> wrote:

> Do you have an IGP running and all interfaces are reachable?
>
>
> On Jun 30, 2010, at 11:43 AM, Ant Lefebvre wrote:
>
> > I am doing a really basic configuration in Narbik's Multicast unsing
> autorp
> > listener. I entered the solution verbatim and can't seem to get it to
> work.
> >
> > I have entered the following commands on all routers
> >
> > ip multicast-routing
> > ip pim autorp listener
> >
> > ip pim sparse-mode <- on every interface
> >
> > Then on one route I enter
> >
> > ip pim send-rp-announce Loopback0 scope 5
> > ip pim send-rp-discovery Loopback0 scope 5 interval 5
> >
> >
> > Problem is that I don't see the PIM Group-to-RP Mappings at ANY router
> other
> > than the one this is configured on.
> >
> > I do a debug and see
> > *Mar 1 01:15:25.547: Auto-RP(0): Build RP-Discovery packet
> > *Mar 1 01:15:25.547: Auto-RP: Build mapping (224.0.0.0/4, RP:1.1.1.3),
> > PIMv2 v1,
> > *Mar 1 01:15:25.551: Auto-RP(0): Send RP-discovery packet of length 48
> on
> > Serial1/0.32 (1 RP entries)
> > *Mar 1 01:15:25.555: Auto-RP(0): Send RP-discovery packet of length 48
> on
> > Serial1/0.35 (1 RP entries)
> > *Mar 1 01:15:25.555: Auto-RP(0): Send RP-discovery packet of length 48
> on
> > Loopback0(*) (1 RP entries)
> >
> > So it is sending, but I see nothing at the routers directly attached when
> > debugging. GNS error???
> >
> >
> >
> > --
> > -Ant
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
> >
> >
> >
> >
> >
> >
>
>

-- 
-Ant
Blogs and organic groups at http://www.ccie.net