RE: CONFIG SECTION

"building a frame switch" ? What track was it ?

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
Jeffrey Pazahanick
Sent: 16-Jun-10 12:30
To: Bernard Steven
Cc: GAURAV MADAN; Cisco certification
Subject: Re: CONFIG SECTION

I agree to save the original configs somewhere... I had a fun
experience of building a frame switch on the wrong router, and after
30 minutes needed to start fresh!

On Wed, Jun 16, 2010 at 10:46 AM, Bernard Steven <buny.steven_at_gmail.com>
wrote:
> Thanks
>
> On Wed, Jun 16, 2010 at 7:43 PM, GAURAV MADAN
<gauravmadan1177_at_gmail.com>wrote:
>
>> Bernard
>>
>> I would say .... PLEASE make it a habit to do this .
>> Who knows that device / devices misbehave and u r required to start
>> over all again.
>>
>> Gaurav Madan
>> CCIE # 23863
>>
>> On Wed, Jun 16, 2010 at 6:23 PM, Bernard Steven <buny.steven_at_gmail.com>
>> wrote:
>> > Experts,
>> > Might be a silly question.
>> > Can we save the initial configs of equipments before we start the
lab(as
>> a
>> > separate copy) , so that in case we need to go back (if messed up).
>> > Is there any use doing that?
>> >
>> > Or is it a "do not " thing in the LAB to save files in the flash. ?
>> >
>> >
>> > Blogs and organic groups at http://www.ccie.net
>> >
>> > _______________________________________________________________________
>> > Subscription information may be found at:
>> > http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Jun 16 2010 - 12:40:41 ART