Re: direct connected AD

Routers do route the packet on 3 basic principles ... when a packet arrives
to the router, the first thing they check is the destination address and
after that they look into the routing table and make bit by bit matching
against the destination address on the criteria of ;

- Prefix length
(high preferred, if equal then)
- Administrative distance
(high low, if equal then)
- Metric
(high low, if equal then)

if all the equal then routers do the load balancing ...

Regards,

On Sun, May 9, 2010 at 10:57 AM, Mahmoud Eldeeb <eng.futurama_at_gmail.com>wrote:

> Dear All,
>
> Is there any way to increase the direct connected network AD to be value
> of
> two or in other way how can I force the core switch to use the static route
> instead of the direct connected.
>
> --
> Best Regards,
> Mahmoud Eldeeb
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Regards,
M. Faisal.
Blogs and organic groups at http://www.ccie.net