RE: eem configuration example

Ali,

It does not seem to be broken:

Anyway again:
http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6555/ps6815/conf
ig_guide_eem_configuration_for_cisco_integrated_services_router_platforms.htm
l

-----Original Message-----
From: imran ali [mailto:immrccie_at_gmail.com]
Sent: Thu 4/22/2010 11:25 AM
To: Narbik Kocharians
Cc: Kambiz Agahian; ehtesham ali; ccielab_at_groupstudy.com
Subject: Re: eem configuration example

wow narbik what's ur typing speed :) ??

kambiz second link seems to be broken ..

thanks

On Thu, Apr 22, 2010 at 11:49 PM, Narbik Kocharians <narbikk_at_gmail.com>wrote:

> Ali,
>
> The examples that Keith and the URL that Kambiz provided are excellent, but
> here is an example that can start you with EEM configuration in a very
> basic
> maner:
>
>
> Configure two applets named R2EEM and R4EEM; the R2EEM should be configured
> such that it assigns an IP address of 10.1.24.2 /24 to the F0/0 interface
> of
> R2, and the R4EEM should be configured such that it assigns an IP address
> of
> 10.1.24.4 /24 to the F0/0 interface of R4. These two applets should also
> enable the F0/0 interface of R2 and R4.
>
>
>
>
>
> *On R2*
>
>
>
> R2(config)#*event manager applet R2EEM*
>
> R2(config-applet)#*event none sync yes*
>
> R2(config-applet)#*action 1.0 cli command "enable"*
>
> R2(config-applet)#*action 1.1 cli command "config terminal"*
>
> R2(config-applet)#*action 1.2 cli command "interface F0/0"*
>
> R2(config-applet)#*action 1.3 cli command "ip address 10.1.24.2
> 255.255.255.0"*
>
> R2(config-applet)#*action 1.4 cli command "no shut"*
>
> R2(config-applet)#*action 1.5 cli command "end"*
>
>
>
> *EEM applets are divided into three sections: *
>
> * *
>
> - *The name: in this case the event manager applet R2EEM command is
> used to name the applet R2EEM .*
> - *The trigger (or event): the trigger is defined with the event none
> sync yes command. This is an event which is used to instruct the applet
> to
> execute. The event none states that there is to be a manual trigger
> which
> means that the applet should be executed from the CLI using the event
> manager run command. The sync yes command instructs the router to run
> the
> commands in this applet synchronously with the router CLI, rather than
> execute them in a batch which helps prevent command overruns.*
>
> * *
>
> - *The action: When the applet executes the commands it uses the action
> statements, these must be numbered in ascending order, in this example
> the
> action statements are to place the router in privilege mode, then, in
> global
> config mode, then, interface configuration mode, then, it assigns an IP
> address, then, enables (NO SHUT) the interface and finally exits back to
> the
> privilege mode. *
>
>
>
> *On R4*
>
>
>
> R4(config)#*event manager applet R4EEM*
>
> R4(config-applet)#*event none sync yes*
>
> R4(config-applet)#*action 1.0 cli command "enable"*
>
> R4(config-applet)#*action 1.1 cli command "config terminal"*
>
> R4(config-applet)#*action 1.2 cli command "interface F0/0"*
>
> R4(config-applet)#*action 1.3 cli command "ip address 10.1.24.4
> 255.255.255.0"*
>
> R4(config-applet)#*action 1.4 cli command "no shut"*
>
> R4(config-applet)#*action 1.5 cli command "end"*
>
>
>
> *To test and verify the configuration:*
>
> * *
>
> *On R2*
>
>
>
> R2#*event manager run R2EEM*
>
>
>
> *You should see the following console message:*
>
> * *
>
> *%SYS-5-CONFIG_I: Configured from console by on vty0 (EEM:R2EEM)*
>
> * *
>
> *R2#Show ip int brief F0/0*
>
> * *
>
> Interface IP-Address OK? Method Status
> Protocol
>
> *FastEthernet0/0 10.1.24.2 YES manual up up***
>
>
>
> *To test and verify the configuration:*
>
> * *
>
> *On R4*
>
>
>
>
>
> R4#*event manager run R4EEM*
>
>
>
> *R4#Show ip int brie F0/0*
>
> * *
>
> Interface IP-Address OK? Method Status Protocol
>
> *FastEthernet0/0 10.1.24.4 YES manual up up** *
>
>
>
>
>
> I hope this helped.
> On Thu, Apr 22, 2010 at 11:04 AM, Kambiz Agahian
> <kagahian_at_ccbootcamp.com>wrote:
>
> > Here is the actual gateway to find all EEM related stuff:
> >
> >
> >
>
>
http://www.cisco.com/en/US/products/ps6815/products_ios_protocol_group_home.h
> > tml
> >
> > And this one is a simple guide to configure ISR boxes with some nice
> > examples:
> >
> >
> >
>
>
http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6555/ps6815/conf
> >
> >
>
>
ig_guide_eem_configuration_for_cisco_integrated_services_router_platforms.htm
> > l
> >
> >
> > HTH
> >
> > --------------------------
> > Kambiz Agahian
> > CCIE (R&S)
> > CCSI, WAASSE, RSSSE
> > Technical Instructor
> > CCBOOTCAMP - Cisco Learning Solutions Partner (CLSP)
> > Email: kagahian_at_ccbootcamp.com
> > Toll Free: 877-654-2243
> > International: +1-702-968-5100
> > Skype: skype:ccbootcamp?call
> > FAX: +1-702-446-8012
> > YES! We take Cisco Learning Credits!
> > Training And Remote Racks: http://www.ccbootcamp.com
> > OEQ Voice Waiver: http://www.ccbootcamp.com/noeqvoice.html
> > OEQ R&S Waiver: http://www.ccbootcamp.com/noeqrs.html
> > OEQ Commercial: http://www.ccbootcamp.com/noeq.mpg
> >
> >
> >
> >
> > -----Original Message-----
> > From: nobody_at_groupstudy.com on behalf of ehtesham ali
> > Sent: Thu 4/22/2010 10:56 AM
> > To: ccielab_at_groupstudy.com
> > Subject: eem configuration example
> >
> > HI group,
> >
> > As i am new to EEM , i just wanted an example task of EEM and any
> reference
> > guides to start off as related to rs exam. (no nda violation :)
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
> >
> >
> >
> >
> >
> >
> >
>
>
> --
> Narbik Kocharians
> CCSI#30832, CCIE# 12410 (R&S, SP, Security)
> www.MicronicsTraining.com
> Sr. Technical Instructor
> YES! We take Cisco Learning Credits!
> Training And Remote Racks available
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Thu Apr 22 2010 - 11:37:58 ART