RE: A Failure - But No Reason

Hi Kanna,

Hopefully it's not too late, but go to the cert support website (or just call
them) and open a case regarding the issue immediately. In your email do
mention the problem but no NDA breakers are necessary. Please leave your
contact details and they will get back to you ASAP. You must have all pieces
of evidence handy and provide enough compeling reasons in the first email.

The fact is you're supposed to do this right after stepping out of the center
but do it now because complaining on forums won't get your chances back.

HTH,

--------------------------
Kambiz Agahian
CCIE (R&S)
CCSI, WAASSE, RSSSE
Technical Instructor
CCBOOTCAMP - Cisco Learning Solutions Partner (CLSP)
Email: kagahian_at_ccbootcamp.com
Toll Free: 877-654-2243
International: +1-702-968-5100
Skype: skype:ccbootcamp?call
FAX: +1-702-446-8012
YES! We take Cisco Learning Credits!
Training And Remote Racks: http://www.ccbootcamp.com

-----Original Message-----
From: nobody_at_groupstudy.com on behalf of Kanna shankar
Sent: Sat 4/10/2010 2:02 AM
To: Cisco certification
Subject: A Failure - But No Reason

Dear All,

I attended SP lab few days before and I experienced an strange issue..

I finished the OEQ section in 15 minutes, answered all the questions
correctly as per book (MPLS IOS Configurations, MPLS Fundamentals, TCP/IP
Vol I & II)
During the lab, after half of MPLS VPN section, my routers started play with
me.. I had to clear the global routing table couple of times, to obtain the
label mapping for any new prefixes..
Since I noticed I was running out of time, I completed all the lab
configurations first. Now I am left with 45 minutes. And now I started to
figure out the issue. I nearly pointed out one router doesn't have proper
forwarding table as per the binding it has. I tried couple of things, but
couldn't get it working..

When I checked with proctor, he said there cannot be any bugs in the
routers..

By this time my lab time is over, I left the exam.I expected OEQ-Pass and
LAB -fail.

But I got the results both failed.........

I tried to do the same config in dynamips (with same image) and exactly got
the issue, and it is listed as a BUG in Cisco site..

I am totally confused.. I am absolutely confident with my configurations and
oeq-answers, from my preparation of nearly 1.5 years. Also I am working on
these configurations from the day one I started my job.

Is CCIE just a game, Cisco use to play with our money? Now I am failed
without knowing the reason, which will not tell me to improve on what
portion?

I would like to listen your suggestions/advice please..

HOPE I didn't violate Mr.CISCO's NDA!!!

Regards,
wanted-to-be-a-ccie

Blogs and organic groups at http://www.ccie.net
Received on Sat Apr 10 2010 - 02:20:16 ART