RE: rsvp qos

Hi Raul,

You only need to enable "rsvp bandwidth" on the multilink interface.
It is not necessary on the serial and virtual-template interfaces.

You would only need "rsvp bandwidth" on the serial interface if a). The
IP address was on the physical interface OR b). If using sub-interfaces
(either pt-p or multipoint) on the serial interface.

Although logically built upon the serial interface, the virtual-template
and multilink interfaces are not treated as sub-interfaces of the serial
interface, hence why you don't need the "rsvp bandwidth" anywhere else.
Similarly, the multilink interface is not a sub-interface of the
virtual-template.

Hope this helps.

Kind regards,
Gavin

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
raul raul
Sent: 02 April 2010 05:19
To: ccielab_at_groupstudy.com
Subject: rsvp qos

Hi GS

would like to seek advise on RSVP, if rsvp going to enable , should we
enable on int virtual template ? or we only enable on s1/0 and multilink
interface ?

where should we enable to make this works and how to test ?

int s1/0
encap frame-relay
frame-relay traffic-shaping
ip rsvp band x x

int s1/0.1 point-to-point
no ip add
frame-relay interface-dlci xx ppp virtual-template 1 class rsvp

int virtual-template 1
no ip add
ppp multilink group 1

int multilink 1
ip add x.x.x.x
ip rsvp bandwidth x x

Blogs and organic groups at http://www.ccie.net
Received on Tue Apr 06 2010 - 00:41:56 ART