RE: intervlan routing basic question

If the question is read literally, it means that both routers are equipped
with ESW modules, VLANs are created on them and they are trunked back to
back. You could change switch port mode to access, disable CDP, enable
bpdufilter to not to confuse anything, and ping SVI to SVI across as much as
you want. Why would anyone need this - a good question.

Adel Abouchaev, CCIE# 12037, CISSP, MCSE

Netmasterclass LLC, Cisco Learning Partner
RFC821: adel_at_netmasterclass.net
E.164: +18886772669
HTTP: www.netmasterclass.net

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
Faisal Ilyas
Sent: Friday, January 29, 2010 2:22 PM
To: Nick Brand
Cc: ccielab_at_groupstudy.com
Subject: Re: intervlan routing basic question

its insane to me ...

how come R1->SW (SVI-VLAN-10-IP 192.168.1.1/24) -> SW (SVI-VLAN-20-IP
192.168.1.2/24)->R2
you must put 192.168.2.1 on SVI of VLAN20 ... else put all routers in the
same vlan 10.

Regards,
M. Faisal.

On Fri, Jan 29, 2010 at 11:24 PM, Nick Brand <nick.brand_at_ymail.com> wrote:

> Hi Folks,
>
> Bear my basic question on intervlan routing.I have two routers R1 and R2
> and
> both are connected thru trunk link.I have an SVI interface vlan 10 ip
> 192..168.1.1 on R1 and SVI interface vlan 20 ip 192.168.1.2 on R2. what
> needs
> to be done so that i could ping them and
> both the svi's are showing to be up up on the routers.i tried enabling
> eigrp
> on them but no go... pls help me on this basic question..
>
> Nick
>
>
>
> Your Mail works best with the New Yahoo Optimized IE8. Get it NOW!
> http://downloads.yahoo.com/in/internetexplorer/
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Fri Jan 29 2010 - 14:44:59 ART