Re: What about the troubleshooting part - allowed commands

I have one small question, if i want to know split horizon status for Eigrp
what are commands available other than sh run ?

On Thu, Jan 28, 2010 at 12:08 AM, Dan Shechter <danshtr_at_gmail.com> wrote:

> Hi Nadeem,
>
> Thanks for the kind words.
>
> You can read all about it at http://dans-net.com
>
> HTH,
> Dan #13685 (RS/Sec/SP)
> Troubleshooting blog: http://dans-net.com
>
>
>
> On Wed, Jan 27, 2010 at 7:41 PM, Nadeem Rafi <nrafia_at_gmail.com> wrote:
>
>> Thanks Dan, i have seen your blog and a great offer for a free TS
>> workbook. In a separate post can you put detail for all ccie candidate about
>> this WB.
>>
>> On Wed, Jan 27, 2010 at 8:35 PM, Dan Shechter <danshtr_at_gmail.com> wrote:
>>
>>> Hi Dennis,
>>>
>>> I have never heard of such a restriction.
>>>
>>> A good trouble-shooting technique is always a combination of "show run"
>>> commands, and other show and debug commands.
>>>
>>> For example: sometimes its so much easier to troubleshoot by comparing
>>> configurations of two routers.
>>>
>>> There are even some TS tasks which you just can't use show commands to
>>> solve, as they can't be tested in the lab, such as some IP services, some
>>> QoS tasks... etc.
>>>
>>> At the end, you will always need the "show run" command to verify that
>>> the
>>> fix you want to apply to the running configuration actually makes sense.
>>>
>>> Note: never use just "show run". You always need to be more specific,
>>> like
>>> "show run | section eigrp". To be more specific, you will need the other
>>> show commands.
>>>
>>> Last, but not least, make sure you practice TS labs only after you have
>>> finished all other practice labs. You will really need all your skills to
>>> do
>>> TS.
>>>
>>> HTH,
>>> Dan #13685 (RS/Sec/SP)
>>> Troubleshooting blog: http://dans-net.com

Blogs and organic groups at http://www.ccie.net
Received on Thu Jan 28 2010 - 00:10:54 ART