Re: Auto-Qos VoIP - Configuration

I was giving an example. If you read the guide I attached it has the
information specific to Serial ports.

-----Original Message-----
From: Mac GroupStudy <mac.groupstudy_at_gmail.com>
To: armylegionmedic_at_aol.com
Cc: ccie_ka_at_gmx.de; iwan_at_ipexpert.com; ccielab_at_groupstudy.com
Sent: Sun, Jan 10, 2010 3:57 pm
Subject: Re: Auto-Qos VoIP - Configuration

I think his question was specific to a Serial interface and not an access
port; I had the same question.

On Sun, Jan 10, 2010 at 12:05 PM, <armylegionmedic_at_aol.com> wrote:

The TRUST statement is for if you have a device on the port that you wish to
trust the markings from. So for example, if you have a phone on that port and
you wish to trust the markings the phone is sending.

To give a bit more detail, here is a specific exert from a Cisco Guide "The
trust optional keyword allows Cisco AutoQoS to trust the DSCP marking of the
traffic and use it to classify that particular type of traffic (Cisco AutoQoS
default is non-trust). If the trustkeyword is not configured, then voice
traffic is classified and marked with the appropriate DSCP values using
nBAR."

Here is the link to the guide
http://www.cisco.com/en/US/tech/tk543/tk759/technologies_white_paper09186a008
01348bc.shtml

-----Original Message-----
From: CCIE-Newbie <ccie_ka_at_gmx.de>
To: Iwan Hoogendoorn <iwan_at_ipexpert.com>
Cc: Cisco certification <ccielab_at_groupstudy.com>
Sent: Sun, Jan 10, 2010 2:25 am
Subject: Re: Auto-Qos VoIP - Configuration

Hi,

and what about the "auto discovery qos[trust]" command ?
Isn't it a requirement for auto-qos ?

thanks

dennis

Am Sonntag, den 10.01.2010, 10:24 +0100 schrieb Iwan Hoogendoorn:
> Hi,
>
> This is only 1 command that you use and it will automatically
> configure QOS for you ...
> You don't need any extra commands ...just make sure if you have 2 way
> traffic autoqos is enabled on both sides ...

Blogs and organic groups at http://www.ccie.net
Received on Sun Jan 10 2010 - 19:55:15 ART