Re: How to remove the offset-list in RIP?? Seriously..

I'm curious about this one, too. I just tried it on 12.2(46)SE and it worked
like a charm... No reload.

On Wed, Jan 6, 2010 at 15:17, Ryan West <rwest_at_zyedge.com> wrote:

> Miroslav,
>
> > -----Original Message-----
> > From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
> > Miroslav Kosut
> > Sent: Wednesday, January 06, 2010 7:26 AM
> >
> > this is only a visage problem. The worse one is with 3560 - If you have
> > an access to 3560 with recent IOS, try to put a multiline "vacant-
> > message" in "line con" mode. The switch will reboot.. :-)) I did it on
> > two different boxes.
> >
>
> What do you consider recent IOS? I tested this on 12.2(44)SE6 and it
> worked out fine.
>
> Rack1SW1(config-line)#do show ver | i IOS
> Cisco IOS Software, C3560 Software (C3560-ADVIPSERVICESK9-M), Version
> 12.2(44)SE6, RELEASE SOFTWARE (fc1)
>
> Rack1SW1(config-line)#do show run | b line con 0
> line con 0
> exec-timeout 0 0
> privilege level 15
> logging synchronous
> vacant-message ^C
> ### Test of a multi line vacant message ###
> ### Will this fail?? ###
> ^C
>
> -ryan
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Jan 06 2010 - 15:30:46 ART