Re: Frame-relay PVC question

Can you also put in your startup config?

-- 
Regards,
Iwan Hoogendoorn
CCIE #13084 (R&S / Security / SP)
Sr. Support Engineer  IPexpert, Inc.
URL: http://www.IPexpert.com
On Mon, Dec 28, 2009 at 12:27 PM, Justin Mitchell <jgmitchell_at_gmail.com> wrote:
> Why does this happen?
>
> Fresh reload of the router, initial configuration is applied, Serial0/0 is
> shutdown, yet DLCI is already assigned to the interface. I figured out the
> way around it but, this is just one of those annoying things. I don't run
> into this everywhere.
>
> Justin
>
> R1#conf t
> Enter configuration commands, one per line.  End with CNTL/Z.
> R1(config)#int s0/0
> R1(config-if)#enc fram
> R1(config-if)#no fram inv
> R1(config-if)#int s0/0.14 p
> R1(config-if)#int s0/0.14 p
> R1(config-subif)#fram inter 104
> %PVC already assigned to interface Serial0/0
> R1(config-subif)#do sh fram pvc | i STAT
> DLCI = 102, DLCI USAGE = LOCAL, PVC STATUS = DELETED, INTERFACE = Serial0/0
> DLCI = 103, DLCI USAGE = LOCAL, PVC STATUS = DELETED, INTERFACE = Serial0/0
> DLCI = 104, DLCI USAGE = LOCAL, PVC STATUS = DELETED, INTERFACE = Serial0/0
> DLCI = 105, DLCI USAGE = LOCAL, PVC STATUS = DELETED, INTERFACE = Serial0/0
> DLCI = 106, DLCI USAGE = LOCAL, PVC STATUS = DELETED, INTERFACE = Serial0/0
> DLCI = 112, DLCI USAGE = LOCAL, PVC STATUS = DELETED, INTERFACE = Serial0/0
> R1(config-subif)#int s0/0
> R1(config-if)#shut
> R1(config-if)#no enc fram
> R1(config-if)#enc fram
> R1(config-if)#no fram inv
> R1(config-if)#int s0/0.14
> % Incomplete command.
>
> R1(config)#int s0/0.14 p
> R1(config-subif)#fram inter 104
> R1(config-fr-dlci)#
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net