Hello Sadiq,
Thanks for your response. I can now see the mac-addresses of the connected
servers.
Regards,
Mayokun.
On Thu, Nov 5, 2009 at 4:01 AM, Sadiq Yakasai <sadiqtanko_at_gmail.com> wrote:
> I see. Agreed something dodgy is up here. Can you try "show mac
> address-table interface g1/x all", see if anything comes up?
>
> Sadiq
>
>
> On Thu, Nov 5, 2009 at 11:48 AM, olumayokun fowowe <olumayokun_at_gmail.com>wrote:
>
>> Below is the 'show module' on the cisco 6509 switch:
>>
>> CAT6509#show module
>> Mod Ports Card Type                              Model              Serial
>> No.
>> --- ----- -------------------------------------- ------------------
>> -----------
>>   1   24  CEF720 24 port 1000mb SFP              WS-X6724-SFP
>> SAL09222220
>>   4   48  CEF720 48 port 10/100/1000mb Ethernet  WS-X6748-GE-TX
>> SAD09200C4W
>>   5    2  Supervisor Engine 720 (Active)         WS-SUP720-3B
>> SAD0919085C
>>   6    2  Supervisor Engine 720 (Hot)            WS-SUP720-3B
>> SAD09200B34
>>
>> Mod MAC addresses                       Hw    Fw           Sw
>> Status
>> --- ---------------------------------- ------ ------------ ------------
>> -------
>>   1  0014.1c11.c3dc to 0014.1c11.c3f3   2.2   12.2(14r)S5  12.2(18)SXD4 Ok
>>   4  0013.8051.2ff0 to 0013.8051.301f   2.2   12.2(14r)S5  12.2(18)SXD4 Ok
>>   5  0011.5cab.5ec4 to 0011.5cab.5ec7   4.4   8.1(3)       12.2(18)SXD4 Ok
>>   6  0011.5cb4.bc78 to 0011.5cb4.bc7b   4.4   8.1(3)       12.2(18)SXD4 Ok
>>
>> Mod Sub-Module                  Model              Serial        Hw
>> Status
>> --- --------------------------- ------------------ ------------ -------
>> -------
>>   1 Distributed Forwarding Card WS-F6700-DFC3B     SAD09070BB1   2.0    Ok
>>   4 Centralized Forwarding Card WS-F6700-CFC       SAL09232FQA   2.0    Ok
>>   5 Policy Feature Card 3       WS-F6K-PFC3B       SAD091607A6   2.1    Ok
>>   5 MSFC3 Daughterboard         WS-SUP720          SAD091204U6   2.3    Ok
>>   6 Policy Feature Card 3       WS-F6K-PFC3B       SAD092009B6   2.1    Ok
>>   6 MSFC3 Daughterboard         WS-SUP720          SAD091204KN   2.3    Ok
>>
>> Mod Online Diag Status
>> --- -------------------
>>   1 Pass
>>   4 Pass
>>   5 Pass
>>   6 Pass
>>
>> The SFP is on module one. The servers are connected directly to module
>> one. So I expect to see the individual mac-addressess of each of the
>> servers.
>>
>> Regards,
>>
>> Mayokun.
>>
>>
>> On Thu, Nov 5, 2009 at 3:06 AM, Sadiq Yakasai <sadiqtanko_at_gmail.com>wrote:
>>
>>> Hi Mayokun,
>>>
>>> I am not very clear about what you are expecting to see. Which of the
>>> interfaces are the SFP ones? Can you provide a "show module" output? From
>>> where I am looking, I dont see what the issue is...
>>>
>>> Sadiq
>>>
>>> On Thu, Nov 5, 2009 at 11:00 AM, olumayokun fowowe <olumayokun_at_gmail.com
>>> > wrote:
>>>
>>>> Hello All,
>>>>
>>>> I came across a situation today which surprised me. I don't know if any
>>>> other person have come across same. I have a cisco 6509 switch with SFP
>>>> fibre module, and  servers are connected directly fo the SFP module
>>>> using
>>>> fibre patch cables. I did a "show mac-address table on the cisco 6509
>>>> switch. I was expecting to see the mac-addresses of the connecting
>>>> devices
>>>> instead I saw a generic mac-address for all the servers connecting to
>>>> the
>>>> SFP module. Moreover I was able to see the mac-addresses of servers
>>>> connected to a similar switch but with a GigabitEthernet module.
>>>>
>>>> CAT6509#sh mac-address-table
>>>> Legend: * - primary entry
>>>>        age - seconds since last seen
>>>>        n/a - not available
>>>>
>>>>  vlan   mac address     type    learn     age              ports
>>>>
>>>> ------+----------------+--------+-----+----------+--------------------------
>>>>
>>>> *  500  3333.0000.000d    static  Yes          -
>>>> Gi1/2,Gi1/3,Gi1/4,Gi1/5
>>>>
>>>> Gi1/6,Gi1/7,Gi1/8,Gi1/9
>>>>
>>>> Gi1/10,Gi1/12,Gi1/13,Gi1/14
>>>>
>>>> Gi1/15,Gi1/16,Gi1/17,Gi1/22
>>>>
>>>> Gi1/23,Gi1/24,Gi4/19,Gi4/43
>>>>
>>>> Gi5/1,Gi6/1,Po23,Router
>>>>                                                   Switch,Stby-Switch
>>>> *  504  3333.0000.000d    static  Yes          -
>>>> Gi1/2,Gi1/3,Gi1/4,Gi1/5
>>>>
>>>> Gi1/6,Gi1/7,Gi1/8,Gi1/9
>>>>
>>>> Gi1/10,Gi1/12,Gi1/13,Gi1/14
>>>>
>>>> Gi1/15,Gi1/16,Gi1/17,Gi1/22
>>>>
>>>> Gi1/23,Gi1/24,Gi4/19,Gi4/43
>>>>
>>>> Gi5/1,Gi6/1,Po23,Router
>>>>                                                   Switch,Stby-Switch
>>>> *   22  0013.7256.7c68   dynamic  Yes         10   Gi5/1
>>>> *   22  0004.fc01.84ba   dynamic  Yes          0   Gi5/1
>>>> *  460  3333.0000.000d    static  Yes          -
>>>> Gi1/2,Gi1/3,Gi1/4,Gi1/5
>>>>
>>>> Gi1/6,Gi1/7,Gi1/8,Gi1/9
>>>>
>>>> Gi1/10,Gi1/12,Gi1/13,Gi1/14
>>>>
>>>> Gi1/15,Gi1/16,Gi1/17,Gi1/22
>>>>
>>>> Gi1/23,Gi1/24,Gi4/19,Gi4/43
>>>>
>>>> Gi5/1,Gi6/1,Po23,Router
>>>>
>>>> I don't know if anybody can explain what might be happening to me.
>>>>
>>>> Regards,
>>>>
>>>> Mayokun
>>>>
>>>>
>>>> Blogs and organic groups at http://www.ccie.net
>>>>
>>>> _______________________________________________________________________
>>>> Subscription information may be found at:
>>>> http://www.groupstudy.com/list/CCIELab.html
>>>>
>>>>
>>>>
>>>>
>>>>
>>>>
>>>>
>>>>
>>>
>>>
>>> --
>>> CCIE #19963
>>>
>>
>>
>
>
> --
> CCIE #19963
Blogs and organic groups at http://www.ccie.net
Received on Thu Nov 05 2009 - 06:50:44 ART
This archive was generated by hypermail 2.2.0 : Tue Dec 01 2009 - 06:36:28 ART