Re: Please answer these questions.

q-1 "To avoid this interoperability issues, do not configure
different candidate RPs to announce partially overlapping group
address prefixes. " -reference ->BSR and RFC 2362 Interoperable
Candidate RP: Example in the documentation cd under configuring basic
ip multicast

q-2 One neighbor command can be used on every other router if
route-reflector is part of the design and three neighbor commands on
the route-reflector making a total of 6 neighbor commands , else if
you have a fully meshed ibgp design then 3 neighbor commands on each
router will be needed making a total of 12 neighbor commands

q-3 port-security has not been enabled with switchport port-security command

HTH

On 9/11/09, imran sheikh <usaimran_at_yahoo.com> wrote:
> Q-1, You are using PIMv2, and there are non-cisco routers in the network,
> how will the rendezvous point be configured?
>
> Q-2, With Four Routers in the network how many neighbour commands will be
> used in iBGP?
>
> Q-3, int Fa 0/1
> switchport mode access
> switchport access vlan 17
> switchport portsecurity maximum 2
> switchport portsecurity violation restrict
> exit
>
> why this security configuration is not working.
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Warm Regards
Peter.
Blogs and organic groups at http://www.ccie.net