Re: per vlan based qos classification/marking on 3560?

I don't think show policy-map interface works on switches, at least from my
experience it gives no output. You may want to try and SPAN a port to get
captures. Did you enable mls qos and vlan-based qos under the physical
interface?

On Thu, Sep 10, 2009 at 1:13 PM, CCIE League <ccieleague_at_ymail.com> wrote:

> vacl can only forward or drop... can use route-map to match vlan 99 & set
> ip prec... but how to do... if Q says use "class-map".
>
> Cheers,
>
>
> ________________________________
> From: Mark Matters <markccie_at_gmail.com>
> To: CCIE League <ccieleague_at_ymail.com>
> Cc: CCIEGS <ccielab_at_groupstudy.com>
> Sent: Thursday, 10 September, 2009 20:01:01
> Subject: Re: per vlan based qos classification/marking on 3560?
>
> Sorry I do not have an example handy. I'll try and find one.
>
> Take a look into vlan maps.
>
> It will be something like this.
> acl
> vlan-map
> vlan access filter.
>
>
> >As I learn more I remember less. I guess my token bucket is rather small.
> >
>
>
> On Thu, Sep 10, 2009 at 2:46 PM, CCIE League <ccieleague_at_ymail.com> wrote:
>
> Experts,
> >
> >How to classify & mark all traffic for only vlan 99 with anything e.g. ip
> prec 5 on a "3560" switch... SW4?
> >
> >
> >Setup:
> >
> > Vlan99----SW1-----isl trunk and ether channel-----SW4
> >
> >
> >- i have enabled "mls qos vlan-based" on the ALL trunk ports on SW4. Can't
> use "mls qos vlan-based" on Port Channel?
> >
> >- SW4 can reach vlan99 via IGP... traffic destined to vlan 999 routed via
> vlan 100.
> >
> >- I have created ACL ANY1 with permit any on SW4
> >
> >- Defined Class-map CM_ANY
> > match access-group name ANY1
> >
> >- Defined Policy-map PM_MARK
> > Class CM_ANY
> > set ip prece 5
> >
> >- Created int vlan 99 on SW4
> >
> >- Under int vlan 99
> > service-policy input PM_MARK
> >
> >#show policy-map interface vlan 99 doesn't show any packets marked!! All
> is showing 0.
> >
> >
> >Have i missed anything? Any tricks?
> >
> >
> >Followed steps on:
> >http://blog.internetworkexpert.com/tag/per-vlan/
> >
> >I have also tried to use Class-map with "match interface f0/19 - f0/24 as
> mentioned in example 6.
> >
> >Ta,
> >
> >
> >Blogs and organic groups at http://www.ccie.net
> >
> >_______________________________________________________________________
> >Subscription information may be found at:
> >http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Bryan Bartik
CCIE #23707 (R&S), CCNP
Sr. Support Engineer - IPexpert, Inc.
URL: http://www.IPexpert.com
Blogs and organic groups at http://www.ccie.net