RE: card type command issue.....again !!

Thank you ....You have been very helpful !!

Finally got over this !!

> From: rwest_at_zyedge.com
> To: cisconuts_at_hotmail.com; ccielab_at_groupstudy.com; cisco_at_groupstudy.com
> Date: Fri, 31 Jul 2009 11:12:07 -0400
> Subject: RE: card type command issue.....again !!
>
> Are you sure how the same type of cards in each router? It sounds like you
may have (2) VWIC2-1MFT-T1/E1's in one router and (2) VWIC2-2MFT-T1(-DI) cards
in the other router. The card type is only needed on the newer cards to
distinguish between a T1 and E1.
>
> -ryan
>
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
Cisco Nuts
> Sent: Friday, July 31, 2009 10:56 AM
> To: ccielab_at_groupstudy.com; cisco_at_groupstudy.com
> Subject: card type command issue.....again !!
>
> Guys:
>
> I am going nuts with the card type command :-(
>
> I have 2 identical routers running identical IOS: 2851 with 12.4-15.T8.bin.
>
> One of them takes the command while the other does not..but the wan comes
up
> fine on both and I am able to access the routers inband.
>
> Keeps giving me: unrecognized command.
>
> Has any one run into this?
>
> The controllers are configured similar for T1 0/0/0 and 0/1/0
>
> To fix this: Does the controller config have to be removed, router rebooted
> and then add the card type commands first?
>
> What is the solution?
>
> Please advise. Thx.
>
> Regards,
>
> CN
>
> _________________________________________________________________
> Windows Live SkyDrive: Store, access, and share your photos. See how.
>
http://windowslive.com/Online/SkyDrive?ocid=TXT_TAGLM_WL_CS_SD_photos_072009
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
Received on Fri Jul 31 2009 - 17:08:34 ART