Re: What do you think - OEQ?

No - from a grading perspective there is no such thing as less or more
credit.

The proctor reads your response and decides if you demonstrated you
know your stuff or not. If yes - you pass the question, if no - you
fail the question.

The idea is to make darn sure you demonstrate you know your stuff.

Warmest Regards,

Anthony J. Sequeira, CCIE #15626
http://www.INE.com

Test your Core Knowledge today!
Q: What feature should you configure if network instabilities impose
high load on router CPU due to perpetual RPF re-calculations?
A: RPF backoff
More Info: http://www.cisco.com/en/US/docs/ios/ipmulti/configuration/guide/imc_sub2nd_convg_ps6017_TSD_Products_Configuration_Guide_Chapter.html#wp1055449

On Jul 28, 2009, at 3:43 PM, <Keegan.Holley_at_sungard.com> <Keegan.Holley_at_sungard.com
> wrote:

> That brings up an interesting question as to how exactly these are
> scored. For example would he be given less credit than someone who
> did not specify the default priority at all? In an interview I
> would consider the candidate that was 1 too high to be more
> knowledgeable.
>
>
>
>
>
> Re: What do you think - OEQ?
>
> Anthony Sequeira to: Molomo
> 07/28/09 10:35 AM
>
> Sent by: nobody_at_groupstudy.com
> Cc: ccielab
>
> Please respond to Anthony Sequeira
>
>
>
>
>
>
> You are on the right track here for sure. In fact, I have had passing
> students actually elaborate down two different paths because the Cisco
> question was so vague. For example, their answer looked something like
> this - "If you meant A with your question, the answer is B. But if you
> meant C with your question, the answer is D." :-)
>
> What you cannot do is write a novel. They have made it clear that they
> will not even bother to read it.
>
> Also, when elaborating, be very sure you are truly technically
> accurate. I notice in your example below you have 32769*MAC. It should
> be 32768 + MAC. :-)
>
> We certainly do not want to inadvertently give the proctor another
> reason to doubt our expertise!
>
> Keep up the great work Molomo!
>
> Warmest Regards,
>
> Anthony J. Sequeira, CCIE #15626
> http://www.INE.com
>
> Test your Core Knowledge today!
> Q: Four NAT terms are used to describe IP addresses in a NAT scenario.
> The address of HostA (inside your corp) as known to HostB (Internet)
> is typically referred to as which term?
> A: The Inside Global Address
> More Info: http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094831.shtml
>
>
> On Jul 28, 2009, at 10:21 AM, Molomo wrote:
>
> > Expert,
> >
> > With OEQ can I give an example, or that might be considered over
> > elaborating?
> >
> > For example wth the question below, which answer will be more
> > appropriate?
> >
> > Question:
> >
> > Between catalyst switch and transparent bridge which is more
> likely to
> > be spanning tree root?
> >
> > Answer 1 :
> >
> > Transparent bridge because it does not use ext system id.
> >
> > Answer 2 :
> >
> > Transparent bridge because it does not use ext system id, eg with
> Vlan
> > 1 default priority, catalyst will have BID of 32769 *MAC and
> > transparent bridge will have BID 32768*MAC
> >
> >
> > Regards,
> > Molomo
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> >
> _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Jul 28 2009 - 16:39:43 ART