Re: E1 connectivity issue/Please help

Thanks a lot.
Works fine.

On Wed, Jul 22, 2009 at 8:26 AM, S Malik <ccie.09_at_gmail.com> wrote:

> For back to back, try clockrate on DCE end too (on the other end clock
> source is network by default (I think).
>
> On Tue, Jul 21, 2009 at 11:52 PM, S Malik <ccie.09_at_gmail.com> wrote:
>
>> You need to use Pins 1,2 4&5 (please double check). You can make a T1 loop
>> back cable, for testing use encapsulation PPP on both routers and test
>> locally if your interface comes up and you see (looped). Test on both
>> routers and then
>>
>>
>>
>> On Tue, Jul 21, 2009 at 9:32 AM, John Pelletier <
>> john.pelletier_at_altima-group.com> wrote:
>>
>>> What type of cable are you using? Back to back has to flip the transmit
>>> and recieve.
>>>
>>> --- On Tue, 7/21/09, Sajjad Najafizadeh <najafizadeh_at_gmail.com> wrote:
>>>
>>>
>>> From: Sajjad Najafizadeh <najafizadeh_at_gmail.com>
>>> Subject: E1 connectivity issue/Please help
>>> To: "Cisco certification" <ccielab_at_groupstudy.com>
>>> Date: Tuesday, July 21, 2009, 5:28 AM
>>>
>>>
>>> Hi All
>>>
>>> I have 2 router with this config :
>>>
>>> 1-2821 with VWIC-2MFT-1/E1
>>> 2-7206 VXR with PA-MC-8TE1 +
>>>
>>> Both routers have E1 module with RJ45 interfaces ( Not serial DCE/DTE )
>>> cable.
>>> The issue is i can not bring up the serial interface even controller E1
>>> that
>>> is directly connected from one router to another.
>>>
>>> Please help .
>>>
>>> Regards
>>>
>>>
>>> Blogs and organic groups at http://www.ccie.net
>>>
>>> _______________________________________________________________________
>>> Subscription information may be found at:
>>> http://www.groupstudy.com/list/CCIELab.html
>>>
>>>
>>> Blogs and organic groups at http://www.ccie.net
>>>
>>> _______________________________________________________________________
>>> Subscription information may be found at:
>>> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Jul 22 2009 - 09:35:35 ART