RE: MPLS TE with OSPF

Can we see the config on R2 ?

CCIE # 23962 (SP)

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of Nitin Venugopal
Sent: Tuesday, July 21, 2009 8:10 AM
To: Cisco certification
Subject: MPLS TE with OSPF

Hi,

I having a problem with my MPLS TE with OSPF-
-----------------------
Topology

R1 - R2 - R3
---------------------
TE Tunnel 13

RI- Head End for the Tunnel
R2- Mid Point
R3- Tail End

--------------------
Router 1 Config

interface Tunnel13
 ip unnumbered Loopback0
 tunnel destination 1.1.1.3
 tunnel mode mpls traffic-eng
 tunnel mpls traffic-eng priority 7 7
 tunnel mpls traffic-eng bandwidth 2000
 tunnel mpls traffic-eng path-option 1 explicit name T13
 no routing dynamic
end

---------------------
IGP
router ospf 100
 mpls traffic-eng router-id Loopback0
 mpls traffic-eng area 0
 router-id 1.1.1.1
 log-adjacency-changes
 network 1.1.1.1 0.0.0.0 area 0
 network 1.1.12.1 0.0.0.0 area 0

------------
debug output

*Mar 1 00:05:03.899: TE-PCALC: bw 2000, min_bw 0, metric: 0
*Mar 1 00:05:03.899: TE-PCALC: setup_pri 7, hold_pri 7
*Mar 1 00:05:03.899: TE-PCALC: affinity_bits 0x0, affinity_mask 0xFFFF
*Mar 1 00:05:03.899: TE-PCALC_PATH: create_path_hoplist: No addresses to
connect 1.1.1.1 to 1.1.12.2

----------

The problem i am facing is MPSL TE tunnel does not come up untill i clear
ospf process on the mid point.
Have tried restarting all the three routers, however unless i clear ospf
process on R2 the tunnel does not come up,

This works with out any problem if i use ISIS as the IGP.

Best Regards
Nitin

Blogs and organic groups at http://www.ccie.net
Received on Tue Jul 21 2009 - 11:17:14 ART