Re: adverising loopback in OSPF Domain

Always remember to use ip ospf network point-to-point" in loopback interface
config to advertise actual subnet mask.

-Raman

On Thu, Jul 16, 2009 at 10:00 AM, Mohamed El Henawy <m.henawy_at_link.net>wrote:

> Thank you All for your replies..
>
> last question....during redistribution part if I found that there is
> network here or there need to be advertised...do I have to do it
> redistribute connected and match the other interfaces in the routing table
> or I can advertise it in any routing protocol running ?
>
>
>
> ----- Original Message ----- From: "Mohamed El Henawy" <m.henawy_at_link.net>
> To: "Cisco certification" <ccielab_at_groupstudy.com>
> Sent: Thursday, July 16, 2009 12:11 PM
> Subject: adverising loopback in OSPF Domain
>
>
>
> Hello Group ,
>>
>> this might be silly question but its really bothering me
>>
>> when I'm asked to advertise "loopback in the OSPF Domain" do I have toe
>> redistribute it or I can just advertise it in any OSPF Area on the
>> router/switch ?
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>>
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Thu Jul 16 2009 - 13:59:02 ART