Re: MPLS L2VPN

ok thanks guys.

We have 2 PEs and MetroSwitches connected to those PEs where CEs connect.

- What will be the port config on the metroswitch facing the CE?
- What should be the port config on the metroswitch facing the PE?

PE1 Config:
=========
l2 vfi CCM manual
 vpn id 100
 neighbor 10.230.55.2 encapsulation mpls

interface Vlan10
 no ip address
 xconnect vfi CCM

 interface GigabitEthernet5/9
 description To MetroSwitch3750
 switchport
 switchport trunk encapsulation dot1q
  switchport mode trunk
 PE2Config:
=========
l2 vfi CCM manual
 vpn id 100
 neighbor 10.230.55.1 encapsulation mpls

interface Vlan10
 no ip address
 xconnect vfi CCM

 interface GigabitEthernet5/9
 description To MetroSwitch3750
 switchport
 switchport trunk encapsulation dot1q
 switchport mode trunk

On Wed, Jul 8, 2009 at 11:44 AM, backbone systems <
backbone.systems_at_gmail.com> wrote:

> There is a short nice article from Petr of IE on VPLS....Poor Man
> VPLS....check this out....
>
>
> http://blog.internetworkexpert.com/category/ccie-service-provider/layer-2-technologies/
>
> Also if u need a quick review...MPLS Configuration on Cisco IOS
> Software has a section on it....
>
> Some real workd stuff,
>
> http://www.networkworld.com/news/2007/031207-verizon-vpls.html
> http://www.podtech.net/home/3180/verizon-bsiness-new-wan-options-with-vpls
>
>
>
> On Wed, Jul 8, 2009 at 10:50 AM, Ali El Moussaoui<mousawi.ali_at_gmail.com>
> wrote:
> > Thanks Danials,
> >
> > I didnt know about VPLS i think i ll have to read more. I have a customer
> > that has around 100 POS and wants to connect them to one central site
> using
> > one VLAN (one L2 broadcast domain). So u have any ref i can start from. I
> > never configured VPLS before!! I provided point to point solution for the
> > timebeing but its not scalable i will have to loose huge number of VLANs
> !!
> >
> > Ali
> >
> > On Wed, Jul 8, 2009 at 10:34 AM, jack daniels <jckdaniels12_at_gmail.com
> >wrote:
> >
> >> Hi,
> >>
> >> For that you have VPLS support. Psudowire are p-2-p.
> >>
> >> Regards
> >> J.Daniels
> >>
> >> On Wed, Jul 8, 2009 at 12:41 PM, Ali El Moussaoui <
> mousawi.ali_at_gmail.com
> >> > wrote:
> >>
> >>> Hello Guys,
> >>>
> >>> Does MPLS L2VPN support point to multipoint? can we have hub and spokes
> >>> topology?
> >>>
> >>> Ali
> >>>
> >>>
> >>> Blogs and organic groups at http://www.ccie.net
> >>>
> >>> _______________________________________________________________________
> >>> Subscription information may be found at:
> >>> http://www.groupstudy.com/list/CCIELab.html
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Jul 08 2009 - 15:43:42 ART