RE: Dynamips with 3725 NM-16ESW

Hi Ed,

You can you as L2 or L3.

For L2: you can use 'vlan database' to configure the VTP domain and VLAN's.
For L3: You can either use SVI or say 'no switchport' on interface to make
it L3.

Hope this will work for you..

Thanks!!

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of omar
parihuana
Sent: Friday, July 03, 2009 9:05 AM
To: Ed Paszko
Cc: Cisco certification
Subject: Re: Dynamips with 3725 NM-16ESW

Hi,

All my routers in my dynagen lab are 3725 some of them with NM-16ESW, you
can use each port as L2 or L3, recall you must create the vlan using vlan
database method.

Rgds.

On Thu, Jul 2, 2009 at 12:14 PM, Ed Paszko <ciscojockey22_at_gmail.com> wrote:

> If anyone is familiar with Dynamips on Ubuntu I would appreciate your help
> with the following question.
>
> I am using all 3725s throughout my configuration.For my four switches I
> have
> added the NM-16ESW module. I would like to know If I can run routing
> protocols on the 4 switches with this module. I also noticed if I make 2
> ports a SVI on this module I can not ping across the directly connected
> interfaces. Is it possible to use these switches in a routing domain? If
> not
> are there alternatives?
>
> Any suggestions would be helpful.
>
> Thanks,
> Ed Paszko
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Omar E.P.T
-----------------
Certified Networking Professionals make better Connections!
Blogs and organic groups at http://www.ccie.net