Re: problem with Enable secret level command

you need to specify the privilege level you are trying to access after the
enable command...

On Tue, Jun 30, 2009 at 10:40 AM, Saketh R <saketh2083_at_gmail.com> wrote:

> Hi All,
> I am having problem with the enable secret level command . I
> wanted to do the following configuration ..
> R2 should telnet to R1 (10.0.0.1) . On giving enable password cisco R2
> should go to privilege level 2 . When I give enable after doing a telnet it
> complains password not set .
> Wherase when I just set the enable secret without specifying the level it
> works fine.
>
> Here are my Logs .
> R1(config)#enable secret level 2 cisco
>
> Telnet from R2 to R1
> ================
> R2#telnet 10.0.0.1
> Trying 10.0.0.1 ... Open
>
> R1>en
> % No password set
> R1>
>
> When using just enable secret it works fine but privilege level is 15
> ===================================================
>
> R1(config)#enable secret cisco
>
> R2#telnet 10.0.0.1
> Trying 10.0.0.1 ... Open
>
> R1>en
> Password:
> R1#sh privilege
> Current privilege level is 15
> R1#exit
>
> [Connection to 10.0.0.1 closed by foreign host]
> R2#
>
>
> Not sure if I am missing something .
>
> Thanks in advance for the help!!!
>
> Saketh
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Jun 30 2009 - 11:32:44 ART