Re: OT:GSR 16 slot deployment querry

Hello Jack,
Yes, you must check the incoming power before pluging power into the GSR
socket.
(I normally do it, as I don't trust electricians, i had some bad
experience).

First if you have grounding wire, connect it to the GSR router. There is a
earthing kit comes iwth it to enable you to hook earth wire into the GSR
chassis.

Point your multimeter on A/C volt. Don't put your lead on A/C power socket
while the multimeter is pointed to other than a/c option.

On power outlet, there should be 3 pins - + , - and GND.

Make sure you pay particular attention to polarities and check positive and
negative points.
Put the red lead to positive and the black lead to negative.

HTH,

frog

There should be reading on the screen of multimeter once you toch + with red
and - with black lead.On Sat, Jun 27, 2009 at 8:10 PM, jack daniels <
jckdaniels12_at_gmail.com> wrote:

> Hi all,
>
>
> I'm deploying GSR -12416 , would request your help in this -
>
> 1) before applying power to the GSR router can I check the power coming
> from
> MAIN POWER UNIT via multimeter , if so how to check <<<<<<<<<
>
>
> Regards
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sat Jun 27 2009 - 21:10:35 ART