Re: ethertypes on doccd?

Hello Wouter!!
I am not sure if this helps, since the doccd, is not the same, as like in
old days :)
but here it goes..

 IOS ->12.3 Family -->12.3 Mainline ---> Command reference ----> Bridging
and IBM network Vol 1 of 2 ----> Appedex.

Cisco IOS Bridging and IBM Networking Command Reference, Volume 1 of 2:
Bridging, Release 12.3
Appendix: Ethernet Type Code

http://www.cisco.com/en/US/docs/ios/12_3/ibm1/command/reference/ib1_ethc.html

On Sun, Jun 14, 2009 at 8:55 PM, Wouter Prins <wp_at_null0.nl> wrote:

> hi all,
>
> I searched the archives for a link to the doccd that will show me the
> different ethertypes for protocols like: pvst(+), mst, ipx and ipv6. I know
> ip and ip arp without any references.
> Is there a way to issue a debug command to find out the ethertype values of
> a particular protocol? I want to avoid learning hex numbers and forget
> about
> them eventually. :)
>
> Tnx.
> --
> Wouter Prins
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Victor Cappuccio
CCIE R/S# 20657
CCSI# 30452
www.anetworkerblog.com
www.linkedin.com/in/vcappuccio
Blogs and organic groups at http://www.ccie.net