RE: AToM FR-Ethernet Interworking problem

Yes, that what I got too after reread Chap 14,L2 VPN Architecture.
Basically, for routed mode, the traffic between CE-PE must be IP. For
switched mode, the traffic between CE-PE must be Ethernet frames. Am I
right?
Thank you all.
Rin

-----Original Message-----
From: Rich Collins [mailto:nilsi2002_at_gmail.com]
Sent: Sunday, May 31, 2009 11:20 PM
To: Rin
Cc: Antonio Soares; Bryan Bartik; ccielab_at_groupstudy.com
Subject: Re: AToM FR-Ethernet Interworking problem

So to get your original configuration working as mentioned above, you
will be modifying R4.
(I used Antonio's helpful mini-scenarios as my basis)

On R4:

!
bridge irb
!

interface Serial1/0
  encapsulation frame-relay
  serial restart-delay 0
 frame-relay map bridge 401 broadcast
 no frame-relay inverse-arp
 bridge-group 1
!
interface BVI1
 ip address 172.10.46.4 255.255.255.0

!
bridge 1 protocol ieee
bridge 1 route ip

-Rich

On Fri, May 29, 2009 at 5:50 AM, Rin <rintrum_at_gmail.com> wrote:
> Hi Bryan, Antonio,
>
> Thank you for your reply. I changed to routed mode and it works. However,
> could you please elaborate more on configuring "frame-relay map bridge" in
> ethenet mode? Note that I made a mistake when stating that pseudowire
> between R1-R4 in my previous post. It is actually pseudowire between R1-R2
> to connect R4 & R6.
> Also, this kind of problem is really hard to troubleshoot, can you suggest
> some troubleshooting technique (procedure, commands...)?
> FYI, I'm using IOS 12.2(25)S9 and it requires to configure the dlci
> switched. But in the book L2 VPN Architecture, it states: " Configuring
the
> switched DLCI is an optional step. If the switched DLCI is not created in
> the interface, it is created with the connect command."
> Thanks
> Rin

Blogs and organic groups at http://www.ccie.net
Received on Mon Jun 01 2009 - 09:21:52 ART