RE: Internetwork expert V4.1-ospf virtual link lab

Milind,

Have you verified that the required virtual links leading to R4 and R3 have been properly built first? If I recall properly, R5 needs a VL to R4 to extend area 0 out to SW2 and R1 and R2 need to be extended to R3 for the link between R4 and R3. And if this is the lab I'm thinking of, I would read the entire section first because you'll authentication for all the links and type 2 authentication for Area 0.

-ryan

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of milind tare
Sent: Monday, May 25, 2009 3:45 PM
To: ccielab_at_groupstudy.com
Subject: Internetwork expert V4.1-ospf virtual link lab

Hi,

I am doing Internetwork experts ospf virtual links lab of repairing discontigious areas from version 4.1.I am trying to configure virtual link from R3 to R4. I am getting following error messages on Routers.
*Mar 1 02:02:50.331: %OSPF-4-ERRRCV: Received invalid packet: mismatch area ID,
 from backbone area must be virtual-link but not found from 2.0.0.2, Ethernet0/0.

R4 to R3 virtual link is up but from R3 to R4 its not showing me up.
Kindly advice.

Thanks and Regards,
Milind

Blogs and organic groups at http://www.ccie.net
Received on Mon May 25 2009 - 16:12:58 ART