Re: Etherchannel Issue

I have heard that a few times in various products although I have never actually tried it. I have always kept it the same on both ends

------Original Message------
From: Dale Shaw
To: Joe Astorino
Cc: CCIE Groupstudy
Subject: Re: Etherchannel Issue
Sent: May 24, 2009 1:09 AM

Hi Joe,

On Sun, May 24, 2009 at 2:36 PM, Joe Astorino <jastorino_at_ipexpert.com> wrote:
> The channel numbers on different switches generally do not matter (you could have po1 on one side and po35 on the other). However, apparently on some specific switches they do need to match so out of habit and for the sake of sanity I always match them

Can you recall where you saw/heard about this? Sounds strange, and if
true, I would it assume would only be the case for PagP (i.e. Cisco
<--> Cisco). Curious!

cheers,
Dale

Regards,

Joe Astorino
CCIE #24347 (R&S)
Sr. Support Engineer  IPexpert, Inc.
URL: http://www.IPexpert.com

Blogs and organic groups at http://www.ccie.net
Received on Sun May 24 2009 - 05:12:40 ART