Re: Wireless highavailability.... Cisco WLAN solutions

The key for roamming is to make sure all your APs have some kind of ovelapping among the AP's, make sure tha roamming is enable which is by default....and you should be fine...the way to test is setup a laptop connect to the wireless network and start pinging an ip address and then move around and see if the pings continues failling and it does then you know that you do not have wireless access on this specifically area and the you need to relocated some APs around....The key about wireless network is the site survey.....

----- Original Message ----
From: Daniel Fredrick <dfredrick_at_gmail.com>
To: jockey wearer <jockeywearer_at_gmail.com>
Cc: GS CCIE-Lab <ccielab_at_groupstudy.com>; security <security_at_groupstudy.com>
Sent: Thursday, May 21, 2009 8:37:47 AM
Subject: Re: Wireless highavailability.... Cisco WLAN solutions

Are you forgetting to say wireless AP? I think you are... but anyways you
have to enable roaming between the APs.

Here is some light reading...

http://www.cisco.com/en/US/docs/wireless/controller/5.2/configuration/guide/c52ccfg.html#wp1098538

I am not sure if you are using LWAPP or IOS on the APs, but this is for
LWAPP, which requires a WLC.

In summary, you need to look up client roaming.

HTH,
Dan

On Thu, May 21, 2009 at 2:50 AM, jockey wearer <jockeywearer_at_gmail.com>wrote:

> Dear All,
>
> I have small query about Wireless Cisco WLAN solutions.
> We have 52 cisco wireless implemented on site and the requirement is If
> employee move from one place to another place he should not be
> disconnected.
> As I beleive If I am connected to One Wireless out of 52 and move to other
> location which doesnot receive the signal of that wireless I will be
> disconnected .
> and need to reconnect other wireless within its range .
> is there any solution for this so i can be get connected ?
> thanks
>
> Regards
> prashant

Blogs and organic groups at http://www.ccie.net
Received on Thu May 21 2009 - 08:20:52 ART