Re: Static RP using a Loopback

As far as i remember, in orlder ios versions u have to specify the pim
sparse-mode under loopback for static-rp and in newer versions u don't have
to or may be the reverse is true. But anyway, its better to put it under
loopback in any case as it will not harm anything.

On Sun, May 17, 2009 at 6:33 PM, antonygrooves <antonygrooves_at_gmail.com>wrote:

> Also when using static RP?, in auto rp or bsr, i always configure it but it
> still works without sparse in Static RP, that was my doubt.
>
> Thanks.
>
>
> Ryan West wrote:
>
>> You must configure sparse mode on the loopback interface as well.
>>
>> -ryan
>>
>> -----Original Message-----
>> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
>> antonygrooves
>> Sent: Sunday, May 17, 2009 10:33 AM
>> To: Cisco certification
>> Subject: Static RP using a Loopback
>>
>> Hi Guys.
>>
>> I have a doubt when configuring static rp and sparse mode, its not clear
>> for me if i have to configure pim sparse mode on the loopback of the RP or
>> not.
>>
>> Thanks for any help.
>>
>> Regards.
>> Tony.
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>>
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sun May 17 2009 - 18:46:23 ART