Re: Dense-mode question

How do you know that traffic is coming from the tunnel and sent to the OIL?
A common problem with tunnels as a source interface for incoming MCast
traffic is the RPF check. Use the "sh ip rpf" command to make sure that the
source IP address of the multicast stream is coming from the Tunnel
interface.

Best regards,
Dan

On Sun, May 10, 2009 at 7:06 PM, Santiago Enciso
<senciso_at_infocenter.com.py>wrote:

> Hello, i'm receiving multicast traffic from a tunnel interface and the
> traffic is been forwarded accoring to the OIL,
> But the neighbor in the mroute show 0.0.0.0, why is this? All my config is
> correct but don't receive icmp replies.
>
> Incoming interface: Tunnel0, RPF nbr 0.0.0.0
>
>
>
> Thanks
>
> Santiago E
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sun May 10 2009 - 19:10:43 ART