Ravi,
I'm pretty sure it has do with scenarios when the link bandwidth has been artificially lowered to affect metrics. Therefore, you may need to increase to 1400 for example if you had set bandwidth to 1 on a 28kbps circuit.
-ryan
-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of Ravi Singh
Sent: Sunday, May 10, 2009 11:36 AM
To: Cisco certification
Subject: EIGRP bandwidth percent
Hi Everyone,
A not-so-important question , just a little curiosity
R1(config)#int s1/0
R1(config-if)#ip bandwidth-percent eigrp 1 ?
<1-999999> Maximum bandwidth percentage that EIGRP may use
Why is the maximum value 999999 when we are talking about percentages here ...
Ravi
Blogs and organic groups at http://www.ccie.net
Received on Sun May 10 2009 - 11:44:05 ART
This archive was generated by hypermail 2.2.0 : Mon Jun 01 2009 - 07:04:42 ART