Re: CEF disabling in the LAB devices

LOL! MPLS was the first thing I thought of when I read the original
post but I hadn't gotten to the v4.0 thread in my inbox as of the time
of writing the below response.

In all seriousness, my point was more general and had more to do with
not encumbering ourselves with a bunch of non-rules and so forth,
thereby adding to the already high level of stress. But you are
absolutely correct Andre that forgetting to re-enable CEF starting
from 18 October could be absolutely deadly to your chances of passing
the lab (if it wasn't already), at least by the grading scripts (you'd
need a very understanding and forgiving proctor to bail you out at
that point!)...

On May 5, 2009, at 7:21 , Dufour, Andre wrote:

> I might want to also add that turning off CEF might lessen your
> chances of passing as MPLS has been included in the upcoming version
> of the lab.... :)
>
>
>
> Andre
>
>
>
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf
> Of Scott M Vermillion
> Sent: Tuesday, May 05, 2009 9:11 AM
> To: Thameem Maranveetil Parambath
> Cc: Peter Kurdziel; Anantha Subramanian Natarajan; Cisco
> certification; nobody_at_groupstudy.com
> Subject: Re: CEF disabling in the LAB devices
>
> While I wouldn't personally recommend this just because of potential
> stability issues (and the risk that you might *introduce* a need for
> the very troubleshooting you're trying to expedite), just as a
> general matter of discussion don't forget all that something as
> easily disabled as CEF can just as easily be re-enabled before
> punching out for the day (assuming you're not in a blind panic and
> prone to forgetting!). My own personal view is that some people get
> WAY too wound up about some of this stuff. I recall prior to my own
> lab I discussed here my general practice of shutting down all
> switchports using 'int range' and then enabling them individually as
> tasks called for their use. You would have thought I committed
> heresy from some of the responses I got. I was all but assured I
> would fail the lab on this count alone. I was also assured I would
> be instantly failed and barred from the lab for saving the initial
> configs to flash at the start of the day. Well, I can assur!
> e you that shutting all the ports didn't hurt me any. As for saving
> to flash, I was made sufficiently paranoid about that not to do it
> but I've since heard from many, many people who did just so (I read
> about it in their pass announcements to the list, so what does that
> tell you?).
>
> The lab is stressful enough without overburdening ourselves with
> non- rules and hearsay. On the other hand, this is most definitely
> *not* a time for free-styling. The goal should be to earn the
> number (or the nth IE) when the scripts go walking through our
> stuff. I wouldn't do anything that would lessen that likelihood and
> this might be one such case. But on the other hand, the lab is not
> a china shop and that's worth bearing in mind too, IMHO...
>
>
> On May 4, 2009, at 10:13 , Thameem Maranveetil Parambath wrote:
>
>> I wont touch anything in the initial config unless there is a
>> troubleshooting section,
>>
>> I believe you will miss points if you remove anything from intial
>> config.
>>
>> Warm Regards,
>>
>>
>>
>>
>> Peter Kurdziel <usaccie_at_gmail.com>
>> Sent by: nobody_at_groupstudy.com
>> 05/05/2009 07:38 AM
>> Please respond to
>> Peter Kurdziel <usaccie_at_gmail.com>
>>
>>
>> To
>> Anantha Subramanian Natarajan <anantha.natarajan_at_gravitant.com> cc
>> Cisco certification <ccielab_at_groupstudy.com> Subject
>> Re: CEF disabling in the LAB devices
>>
>>
>>
>>
>>
>>
>> I don't know but I personally would not do anything that was not
>> specifically stated in the lab tasks.
>>
>>
>> On Mon, May 4, 2009 at 11:10 PM, Anantha Subramanian Natarajan <
>> anantha.natarajan_at_gravitant.com> wrote:
>>
>>> Hi All,
>>>
>>> Assuming disabling CEF would help to run debugs on the LAB
>>> devices..Is
>> it
>>> advisable to disable CEF in the LAB premenanetly and also is there
>>> any feature required in the LAB would depend on CEF enabling.Kindly
>>> let me
>> know
>>>
>>> Thanks
>>>
>>> Regards
>>> Anantha Subramanian Natarajan
>>>
>>>
>>> Blogs and organic groups at http://www.ccie.net
>>>
>>> _____________________________________________________________________
>>> __ Subscription information may be found at:
>>> http://www.groupstudy.com/list/CCIELab.html
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>
>>
>> --
>> Regards,
>> Peter Kurdziel
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> ______________________________________________________________________
>> _ Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>> The content of this email together with any attachments, statements
>> and opinions expressed herein contains information that is private
>> and
>> confidential and intended for the named addressee(s) only. If you are
>> not the addressee of this email you may not copy, forward, disclose
>> or
>> otherwise use it or any part of it in any form whatsoever. If you
>> have
>> received this message in error please notify postmaster_at_etisalat.ae
>> by
>> email immediately and delete the message without making and copies.
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> ______________________________________________________________________
>> _ Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue May 05 2009 - 08:05:45 ART