Re: PPTP WITH ISA

Dear plz find below my router configuration

MD-005#sh run
Building configuration...

Current configuration : 1968 bytes
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname MD-005
!
boot-start-marker
boot-end-marker
!
enable secret 5 $1$WP96$zGaFBqkGZc/whc1GZd77e.
!
aaa new-model
!
!
!
!
aaa session-id common
!
!
dot11 syslog
no ip dhcp use vrf connected
ip dhcp excluded-address 192.168.1.1
!
ip dhcp pool 1
   network 192.168.1.0 255.255.255.0
   default-router 192.168.1.1
   dns-server 212.76.68.200 212.76.68.201
   lease 0 2
!
!
ip cef
ip name-server 212.76.68.201
ip name-server 212.76.68.200
!
!
!
username admin password 7 0005170B0D55
!
!
archive
 log config
  hidekeys
!
!
!
!
!
interface ATM0
 no ip address
 no atm ilmi-keepalive
 pvc 0/35
  pppoe-client dial-pool-number 1
 !
 dsl operating-mode auto
!
interface FastEthernet0
!
interface FastEthernet1
!
interface FastEthernet2
!
interface FastEthernet3
!
interface Vlan1
 ip address 212.76.78.81 255.255.255.248 secondary
 ip address 192.168.1.1 255.255.255.0
 ip nat inside
 ip virtual-reassembly
 ip tcp adjust-mss 1452
 hold-queue 100 out
!
interface Dialer1
 ip address negotiated
 ip mtu 1442
 ip nat outside
 ip virtual-reassembly
 encapsulation ppp
 ip tcp adjust-mss 1394
 dialer pool 1
 dialer remote-name redback
 dialer-group 1
 ppp authentication pap chap callin
 ppp chap hostname ysteel2_at_4096.sahara.net.sa
 ppp chap password 7 061F1C35494B054B
 ppp pap sent-username ysteel2_at_4096.sahara.net.sa password 7 08385F5A0C1C0
 ppp ipcp dns request
 ppp ipcp wins request
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 Dialer1
!
ip http server
no ip http secure-server
ip nat inside source list 123 interface Dialer1 overload
!
access-list 23 permit any log
access-list 102 deny ip 192.168.1.0 0.0.0.255 192.168.0.0 0.0.255.255
access-list 102 permit ip 192.168.1.0 0.0.0.255 any
!
control-plane
!
!
line con 0
 no modem enable
line aux 0
line vty 0 4
 access-class 23 in
!
scheduler max-task-time 5000
end

MD-005#

Thanks.

On Sat, Apr 11, 2009 at 6:09 PM, Radioactive Frog <pbhatkoti_at_gmail.com>wrote:

> Make sure that you are not using NAT on the router. If you are using NAT
> then you need to map your WAN IP's for PPTP ports to your ISA server. So
> when pptp request comes router throughs it direct to ISA server.
>
> Post your router config.
>
> frog
>
>
>
> On Sat, Apr 11, 2009 at 9:23 PM, marish shah <contactmarish_at_gmail.com>wrote:
>
>> HI Experts,
>> I'm trying to establish a pptp connection from outside to
>> my
>> ISA server,My scenario is simple, I'm using CISCO 857 and after this ISA
>> server and I enable pptp on ISA I did'nt configure any pptp configuration
>> on
>> CISCO 857,So when I try to establish my VPN connection from inside ( same
>> LAN ) I can its work fine but from outside I can't Its show username &
>> password prompt n when I put its not work,So my Q is there any config for
>> pptp needed on CISCO 857 if yes then what it is .And If there is no config
>> needed so where is problem.
>>
>>
>> Thanks,
>> Regards,
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sun Apr 12 2009 - 09:54:45 ART