From: Shaukat Khalil (shkhalil) (shkhalil@cisco.com)
Date: Wed Mar 25 2009 - 01:42:17 ART
Kashif,
Use " show ip eigrp interfaces detail int type <x/y> "
Shaukat
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Kashif.Nadeem/Network Technology/Lahore
Sent: Tuesday, March 24, 2009 9:23 PM
To: CCIE R/S, Groupstudy
Cc: Narbik Kocharians; Scott M Vermillion
Subject: EIGRP Hello timer
Hi guys
I have changed hello timer of EIGRP and now I want to see that changed
timer , but I issue all commands regarding EIGRP hello timer but still I
did not get.
I issue eigrp neighbor command it shows only holddown timer not hello
timer
Please tell me where to see this EIGRP changed hello timer.
Best Regards,
Kashif Nadeem
Data Services and Security Engineer
Engineering (NSS).
M | +92 (322) 4003108
F | +92 (42) 5786759
IPT | 41890
1st Floor EFU House, Jail Road, Lahore, Pakistan
Note: This Transmission is confidential and intended solely for the
person or organization to which it is addressed and may contain
privileged or confidential information. If you are not the intended
recipient, you should not copy, distribute or take any action in
reliance on it. If you have received this transmission in error, Please
notify the send at the email address above.
Warid is a joint venture of Abu Dhabi Group and SingTel
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Apr 06 2009 - 06:44:07 ART