From: Thameem Maranveetil Parambath (tparamba@thecontactcentre.ae)
Date: Mon Mar 09 2009 - 02:38:24 ARST
> I used command
> vlan dot1q tag native
> To sent native vlan tagged ....
but I am still getting vlan mismatch
error
Hi JAZ,
What i understand
about native vlan is , it is being used for not tagging
the frames
That
is if we use vlan 20 as native vlan , those frames that belong to the
vlan
20 wont get tagged when it is send from sw1 to sw2...
Say if we use vlan 1
as native vlan, all frames belonging to vlan 20
would get tagged while
sending from sw1 to sw2...
Is my understanding correct?
Regards,
Thameem
Pradeep Chandrashekaran <chanpraddy@gmail.com>
Sent by:
nobody@groupstudy.com
08/03/2009 07:23 AM
Please respond to
Pradeep
Chandrashekaran <chanpraddy@gmail.com>
To
JAZ <azeemu@gmail.com>
cc
Cisco certification <ccielab@groupstudy.com>
Subject
Re: vlan dot1q tag
native ....
Hi JAZ,
You will need to configure the
command on both ends of the trunk
link, not just sw1.
Thanks
Pradeep
On Sat, Mar 7, 2009 at 9:00 PM, JAZ <azeemu@gmail.com> wrote:
> Hi Guys,
>
I am using 2 sw
> sw1----sw2
> I configure dot1Q on both switches. On sw1 I
changed native VLAN 10 .
Then
> ,
> I am getting error regarding native
vlan mismatch.I used command
> vlan dot1q tag native
> To sent native vlan
tagged .... but I am still getting vlan mismatch
error
> !
> Need help
>
Thanks
>
>
> Blogs and organic groups at http://www.ccie.net
>
>
This archive was generated by hypermail 2.1.4 : Mon Apr 06 2009 - 06:44:04 ART