From: darth router (darklordrouter@gmail.com)
Date: Sat Mar 07 2009 - 16:36:44 ARST
Are you using GNS3? I've had to manually edit the net file created by GNS3
to get ATM working.
On Fri, Mar 6, 2009 at 11:07 PM, Vignesh Sethuraman
<sethuvignesh@gmail.com>wrote:
> Hello,
>
> I was configuring basic atm configuration between 2 routers connected via
> ATM switch in my 4 GB Ram laptop running WindowsXP.
>
> R1(3/0) ------ 1/0 (ATM SW) 2/0 ------(3/0) R2
>
> I am unable to ping R1 to R2
>
> R1:
> interface ATM3/0
> ip address 150.1.19.1 255.255.255.0
> no atm enable-ilmi-trap
> no clns route-cache
> pvc 0/102
> protocol ip 150.1.19.2 broadcast
>
> R2:
> interface ATM3/0
> ip address 150.1.19.2 255.255.255.0
> no atm enable-ilmi-trap
> no clns route-cache
> pvc 0/102
> protocol ip 150.1.19.1 broadcast
>
> R1#p 150.1.19.2
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 150.1.19.2, timeout is 2 seconds:
> .....
> Success rate is 0 percent (0/5)
> R1#
> I have started my Cell mode atm switch. But i did not do any mappings on
> the
> ATM switch. Do we need to configure mappings on the ATM switch as like the
> FRSW. I am using InternetworkExpert .net file.
>
> And also CPU process is showing 100% even if i choose the best idlepc shown
> in the GNS.
>
> Could you pleas help me to resolve this issue.
>
> Thanks,
> Vignesh
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Apr 06 2009 - 06:44:04 ART