From: Vignesh Sethuraman (sethuvignesh@gmail.com)
Date: Sat Mar 07 2009 - 06:07:11 ARST
Hello,
I was configuring basic atm configuration between 2 routers connected via
ATM switch in my 4 GB Ram laptop running WindowsXP.
R1(3/0) ------ 1/0 (ATM SW) 2/0 ------(3/0) R2
I am unable to ping R1 to R2
R1:
interface ATM3/0
ip address 150.1.19.1 255.255.255.0
no atm enable-ilmi-trap
no clns route-cache
pvc 0/102
protocol ip 150.1.19.2 broadcast
R2:
interface ATM3/0
ip address 150.1.19.2 255.255.255.0
no atm enable-ilmi-trap
no clns route-cache
pvc 0/102
protocol ip 150.1.19.1 broadcast
R1#p 150.1.19.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 150.1.19.2, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
R1#
I have started my Cell mode atm switch. But i did not do any mappings on the
ATM switch. Do we need to configure mappings on the ATM switch as like the
FRSW. I am using InternetworkExpert .net file.
And also CPU process is showing 100% even if i choose the best idlepc shown
in the GNS.
Could you pleas help me to resolve this issue.
Thanks,
Vignesh
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Apr 06 2009 - 06:44:04 ART