From: operator sid (ccie1@live.co.uk)
Date: Mon Mar 02 2009 - 10:54:56 ARST
I just found if you do Show cdp neighbour detail .. it shows it there..
Thanks
Date: Mon, 2 Mar 2009 15:19:47 +0300
Subject: Re: Catalyst 6500 telnet to Module
From: farrukhharoon@gmail.com
To: ccie1@live.co.uk
CC: ccielab@groupstudy.com
1) If you console to the SUP you can use the 'switch console' command to move
to the MSFC console (and using CTRL-C-C-C to get back). I don't think you can
switch in case of telnet.
2) Same as above. You can't go to the host box from within the FWSM telnet
session AFAIK. However you can access the FWSM from the switch console using
the 'session slot x processor 0' command.
Regards
Farrukh
On Mon, Mar 2, 2009 at 3:08 PM, operator sid <ccie1@live.co.uk> wrote:
Hi Group
On a Cat6500 in hybrid mode, if you have telnetted directly to the MSFC and
want to get onto the switch processor, how can you do this if you dont know
the IP of the switch processor
Also if you telnet to a FWSM and want to get onto it Switching engine, but
dont know its IP, how can you do this from the FWSM?
Thanks in advance
This archive was generated by hypermail 2.1.4 : Mon Apr 06 2009 - 06:44:03 ART