From: Nitin Venugopal (nitinsworld@gmail.com)
Date: Fri Feb 20 2009 - 17:57:44 ARST
Dear All,
I am facing an issue with PIM neighbouship not getting established over the
multicast VPN
|------------------------<MDT>---------------------|
R1--------------(Et0/1) R2-----------------IBGP--------------R3
(Fa0/0)---OSPF---R4-------OSPF-------R5 (E01)---
vrf
A mpls vrf
A RP
1. R5-- RP (Static)
2. R5's (e0/1) is configured with IGMP join group command
3. Sparse mode has been configured properly
4. With the LB's over which the ibgp is established is also enabled for PIM
sparse mode.
5. show mpls interface shows themdt tunnel as up.
6. When traffic is initiated from R1, it does not bring up R3 ..ip pim
neighbor still remain with other neghbors
Diagnosis
1. when i issue show ip pim neighbor, i cannot see R3 as neighbor tO R2
2. However the tunnel is up - when ip pim vrf ABC intreface cmd is issued.
Appriciate if someone can revert with the corect sollution
Thanks
Nitin
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sun Mar 01 2009 - 09:44:12 ARST