From: Jonny English (redkidneybeans@gmail.com)
Date: Tue Dec 23 2008 - 19:25:51 ARST
under the vlan database right?
On Wed, Dec 24, 2008 at 6:08 AM, Muhabat Khan <muhabat@gmail.com> wrote:
> first two can be done
>
> Cannot configure VLANs from config mode (only vlan database)
> * Cannot change VTP Mode
> on newer ios these are supported .... vtp mod can be changed on older
> systems also.
>
> HTH
>
>
> On Tue, Dec 23, 2008 at 7:54 PM, Bogdan Sass <bogdan.sass@catc.ro> wrote:
>
>>
>> Jonny,
>>>>
>>>> Thanks for your reply.
>>>>
>>>> Are these typical issues with dynamips/Dynagen listed somewhere.
>>>>
>>>>
>>> Issues with NM-16ESW:
>> * Cannot configure VLANs from config mode (only vlan database)
>> * Cannot change VTP Mode
>> * Cannot do ISL trunking
>> * Cannot enable bpdu-guard on interfaces
>> * Cannot do private VLANs
>> * Cannot do PAgP / LACP
>> * Cannot set switch ports to nonegotiate
>> * Cannot change SDM (Switch Database Templates) ).
>>
>> I don't remember exactly where I found them (somewhere on the dynamips
>> forums, as far as I remember :) ).
>>
>> Also, from what I remember, NM-16ESW cannot do .1q tunnelling. (correct
>> me if I'm wrong on this one)
>>
>> Also, another problem I had with dynamips was the one discussed recently
>> on the list - layer 3 ports on a NM-16ESW not coming up on the first try.
>>
>> While this might seem like a long list, don't let it discourage you from
>> using dynamips! I did about 90% of my lab preparation on dynamips, and it
>> _definitely_ is a very good solution for those of us not affording a full
>> equipment rack (or hundreds of hours of lab rentals).
>>
>> --
>> Bogdan Sass
>> CCNP,CCSP,JNCIA-ER,CCIE #22221 (RS)
>> Information Systems Security Professional
>> "Curiosity was framed - ignorance killed the cat"
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Thu Jan 01 2009 - 12:53:09 ARST